1999 parts swap to 1989
11-18-2011, 02:48 AM
#2
CF Veteran
Join Date: Jun 2011
Location: S.E. Tx
Posts: 1,845
Likes: 0
Received 2 Likes
on
1 Post
Year: 1992
Model: Cherokee
Engine: 4.0 I6 firepower ignition, cat-back w/ magnaflow muffler, poweraid tb spacer, optima blue top
Depends, there were a couple options for both years. For the '89 it would either be a Dana 35 or a Dana 44. For the '99 it would either be a Dana 35 or Chrysler 8.25". Are you looking to swap?
11-18-2011, 05:42 PM
#4
Junior Member
Join Date: Sep 2011
Location: Lake Murrieta, CA
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4
Yes the same, but the e-brake lines are different and can be swapped. '99 will have lines that go to the drivers side and the '89 will have lines that go to the center. Disconnect them from inside the brake assembly. You just need to pull the sping back and pull the wire from the lever, then just unclip it from the backing plates. Reverse for install.
11-18-2011, 05:57 PM
#5
CF Veteran
Join Date: Jun 2011
Location: S.E. Tx
Posts: 1,845
Likes: 0
Received 2 Likes
on
1 Post
Year: 1992
Model: Cherokee
Engine: 4.0 I6 firepower ignition, cat-back w/ magnaflow muffler, poweraid tb spacer, optima blue top
You might also need to swap driveshafts as well, depending on what diffs each xj has.
Thread
Thread Starter
Forum
Replies
Last Post
cherokee01
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
08-30-2015 05:04 AM
Big Ray
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
08-27-2015 08:54 PM
olas
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
08-27-2015 05:57 PM
d00med
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
08-26-2015 12:33 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
