01 need post rebuild help
Thread Starter
Newbie
Joined: Nov 2013
Posts: 22
Likes: 2
From: SW Montana
Year: 2001
Model: Cherokee
Engine: 4.0 six
01 need post rebuild help
I just finished a rebuild of my 01 Cherokee Sport.
Started up ok then would not start again - crank position senor was bad (also was new) replaced crank sensor starts fine but when I put it in gear nothing happens - I also get nothing on my OBD II - blank screen
Any thoughts/ideas?
2001 Cherokee Sport
4.0 six
automatic trans
Started up ok then would not start again - crank position senor was bad (also was new) replaced crank sensor starts fine but when I put it in gear nothing happens - I also get nothing on my OBD II - blank screen
Any thoughts/ideas?
2001 Cherokee Sport
4.0 six
automatic trans
Thread Starter
Newbie
Joined: Nov 2013
Posts: 22
Likes: 2
From: SW Montana
Year: 2001
Model: Cherokee
Engine: 4.0 six
Thanks for the reply
All fuses checked out fine
Is there a relay or similar?
Also, why no reading from my code reader? I'll try it on another vehicle to make sure it is ok
All fuses checked out fine
Is there a relay or similar?
Also, why no reading from my code reader? I'll try it on another vehicle to make sure it is ok
Thread
Thread Starter
Forum
Replies
Last Post
mattyice
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
Mar 27, 2016 09:05 PM
Dylan86cherokee
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
Mar 24, 2016 01:01 PM
Arab1970
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
Apr 24, 2008 05:03 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)