Need a cv style shaft. I'm located on Cape Cod and will about an hour or so.there are a few local junkyards that have what I need but wanted to post here to give money to a fellow jeeper. PM if you have any j fiya.

Any info*

I had a shaft made for pretty cheap when I lived on the cape not very long ago. I think he was in mashpee. You might want to talk to mark at dr.wheels in hyannis also. They may have something around to help you out from one of the folks in the jeep club there.

Also I've got a zj front shaft, not the yoke variety. Leftover from a recent xfercase swap. Not sure if that's what yiur looking for...

I would like the Cv style to go with my SYE. Is yours double u joint? Where are you located?

I recently installed an XJ front shaft on a ZJ for a guy. bolted right up.
Id go $70 shipped for one.

I'm actually looking for the opposite. I have an xj and need the longer front shaft for my rear. I actually just purchased a tcase with a SYE kit installed already. It was a double u joint setup so if you have the same length with u joint setup ill take it

Check some tj front shafts also

What years?

All tj's , the shaft length varied

Ok. I've been looking at some Dakotas too, depending in the transfer case type. I orinigally wanted to have all the parts I need before I do my lift since this is my daily driver and I want to get it all done in a weekend...I'm thinking that since I'm doing a pieced together lift instead of a package lift like rough country or RE I'm going to need to do my lift and measure length ill need, or have a couple different driveshafts handy so I,don't run into an issue not having a driveshaft

Still have u bolt style? I still need a DS. Its the last piece of my lift I need