LOL have fun, ask for a four horseman at the bar

 

Why aren't you making kits?

 

Im interested

 

is it made for some companies long arms, or for like a custom 3 0r 4 link setup?

 

I never got around to making kits. I can get more of them made.
It should work for most kits. I'm on my phone I'll post pics tonight of it when I get on the computer.

 

Still waiting on pics, u think the crossmember would work with my rubicon espress arms?

 

okay heres the deal with the crossmember...

the crossmember will fit anything might need a little bit of work to fit your jeep. i have only used this design with my arms, my arms are 31 inches eye to eye so if your somewhat close to that then yes it will work. the tabs are made to accept a 3/4 inch bolt which is what a heim joint uses when misalignment spacers are added.
if you want me to give you the tabs with a smaller hole i can get new tabs with smaller holes. the tabs are not welded onto the x member yet so you have options as far as where you want to mount the arms to best fit your xj.
the x member is made to bolt inside the frame rails using 1/2 inch bolts that will go thru your frame rails.
i have ran this set up with no plating to reinforce the frame rails and have not had any problems yet. i do recommend using as big of a washer as possible for the bolts.

I HAVE ENOUGH PIECES TO MAKE TWO OF THESE














I also found this bung that i dont need unfortunately i only have one of them
its for a 1 1/4 heim or johnny joint

 

I'm still very interested in it as I was back on pirate....

edit: nm, just read over everything.....good luck with the sale

 

TIG welding looks nice man.

 

Thanks^

Make an offer I need jeep money

 

anyone interested?
feel free to make an offer.

 

Any pics of it on your jeep? I would like to long arm my little 2wd

 

I'm on my phone right now but if you look at my build thread there's pics of the same set up on my jeep. There's a link to my build in my signature

 

Any takers?

 

Whats the lowest price youll take?