Electric Fan Conversion Kit!
#31
CF Veteran
Join Date: Feb 2010
Location: Allentown, Pa
Posts: 3,869
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1994
Model: Cherokee
Engine: 4.0L HO
I just purchased a shroud and controller from you guys the other day. I'm going to run my own fans because I get a very good deal on them (And already have several of them sitting on my parts shelf.) Any chance you could share your wiring schematics for your setup? I'd greatly appreciate it, thanks.
#32
Seasoned Member
Join Date: Sep 2012
Location: Oceano, Ca
Posts: 505
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: ATK 4.0L I6 w/ AEM Brute Force inatke, 748 Injectors
So if the other two fan kick on at 205 and my heep (on street) usually stays dead center at 210 does that mean that the fans will be constantly kicking on when it hits "normal" temp then off when it gets lower, then back on again when it returns?
#33
Former Sponsor
Thread Starter
Join Date: Mar 2011
Location: Center City, MN
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
They might be "on and off" but the system keeps the temps at a very consistent temperature, usually stays right around 210f.
#34
Seasoned Member
Join Date: Sep 2012
Location: Oceano, Ca
Posts: 505
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: ATK 4.0L I6 w/ AEM Brute Force inatke, 748 Injectors
I'm getting thee ol' 00-01 heat soak issue anytime I take the Heep out on the dunes (I live 5 mins from Pismo) and last time it actually died going up a dune, had to roll it down and wait for like 20 till it cooled off, so I'm looking into a cooling system upgrade. Does the fan stay on after the ignition is off? From what ive researched , this is what causing my heat soak/vapor lock issue. Is there a switch for manually turing the system on and off so when I'm going to be romping around I can run it?
Thanks,
Mike
Thanks,
Mike
#35
Former Sponsor
Thread Starter
Join Date: Mar 2011
Location: Center City, MN
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
I'm getting thee ol' 00-01 heat soak issue anytime I take the Heep out on the dunes (I live 5 mins from Pismo) and last time it actually died going up a dune, had to roll it down and wait for like 20 till it cooled off, so I'm looking into a cooling system upgrade. Does the fan stay on after the ignition is off? From what ive researched , this is what causing my heat soak/vapor lock issue. Is there a switch for manually turing the system on and off so when I'm going to be romping around I can run it?
Thanks,
Mike
Thanks,
Mike
You can wire the temp sensor to the battery and once it heats up the fans turn on and once it cools off they will go off automatically so if they are on when you park they may stay on for a few min after turning the engine off.
You can use a diode to bypass the sensor and control the fans manually, the same way the AC turns them on.
#37
CF Veteran
Join Date: Mar 2012
Location: whiting
Posts: 1,414
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0
Originally Posted by 99superjeep01
Hmm ok. And I know it says the fans are in red for illustrations, but do you sell them in red? I have a red xj that's why I ask lol.
#40
Senior Member
Join Date: Mar 2011
Location: VA
Posts: 770
Likes: 0
Received 1 Like
on
1 Post
Year: 2000
Model: Cherokee (XJ)
Engine: 4L, 6 cylinder, 190 hp, 225 ft lp torque
I'm considering ordering this system because of the heat soak issues that I have while offroading. I have a question about the A/C electric fan system. After installing your system, when I turn on the A/C, none of the fans will come on until the temp rises. Is that correct?
I guess that I could connect one fan to the existing A/C wiring and the other two fans individually from your controller and relays. Thanks.
I guess that I could connect one fan to the existing A/C wiring and the other two fans individually from your controller and relays. Thanks.
#45
Member
Join Date: Jan 2013
Location: Gray, Louisiana
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L Stock Straight 6
Thinking about ordering the 3 fan mod. I was wondering if I can wire the 3 fans directly to 3 switches and control which ones I want on at what times?