Tidewater/Hampton Cherokees????
#1894
Junior Member
Join Date: Sep 2013
Location: Fort Eustis Virginia
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: l6
where are you located I need a few interior parts. Little stuff here and there to finish mine up
#1896
☠ CF Sheriff ☠
any good places to get a cheap but yummy meal in Suffolk? Preferably with craft beer.
#1898
Junior Member
Join Date: Sep 2013
Location: Fort Eustis Virginia
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: l6
Hey guys, just picked up a lock rite locker from a guy today and its already in the carrier with new bearings on it and new springs installed. anyone know if I have to take it apart and use my carrier and stuff or can I use it like it is?
#1900
Junior Member
Join Date: Sep 2013
Location: Fort Eustis Virginia
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: l6
Its for a Dana 30, it was in the front axle of another xj but the motor blew so it was being parted out. I only wanted the locker but when I picked it up it was all together mew bearings and all. I don't know the gear ratio of it
#1901
CF Veteran
Join Date: Jan 2010
Location: Virginia Beach by way of Michigan
Posts: 5,482
Likes: 0
Received 24 Likes
on
24 Posts
You need to either find that (the gear ratio) out or just use your current carrier then. Once you go to 3.73's or lower a different carrier is used. My suggestion is to just use your current one, that way there are zero doubts about it being the correct one for your current gear set up.
#1902
Junior Member
Join Date: Sep 2013
Location: Fort Eustis Virginia
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: l6
You need to either find that (the gear ratio) out or just use your current carrier then. Once you go to 3.73's or lower a different carrier is used. My suggestion is to just use your current one, that way there are zero doubts about it being the correct one for your current gear set up.
Yea, I'll just use mine then. Thanks for the help guys, I'm going to put it in today.
#1903
Beach Bum
#1905
Beach Bum
D30 Lunchbox
I haven't done it in the D30 yet, just researched it. Seems the roll-pin is the issue. In write-ups the ring gear has to be removed to be able to punch out the pin. Seemed like the only way?