Just put in new engine and my tranny line that goes to the radiater didn't fit. Trimmed the stub on the radiator and now it clicks in but of course it leaks now. Was just wondering since I'm putting in a new tranny cooler anyway can i just run a regular hose and clamp it or is there too much pressure? Also have no oil pressure according to guage. Could this be a fuse? Put new sender unit in when I swapped the motor. Any help would be appreciated.

 

Yes you can use regular rubber line for your tranny lines they only have about 8-10 psi.Try putting on a mechanical gauge just check your oil pressure ,next step most likely sending unit. good luck .sry forgot you already did sensor

 

Thanks Rich. After writing this I took the new pressure sensor back and got another new one. I installed and now it's reading 40-45 psi. Will put in larger tranny cooler and swap those lines tomorrow.