installing steer stabilizer
#2
Senior Member
Join Date: Dec 2008
Location: northwest Indiana USA
Posts: 606
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990 laredo
Model: Cherokee
unbolt old stabilizer. remove it. (pickle fork or mallet may be helpful here) Examine mounting points on truck for damage or excessive wear, they should be fine. Install new stabilizer. enjoy.
#3
CF Veteran
Join Date: Feb 2009
Location: birmingham,england.
Posts: 1,983
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0 ltr
with due respect you missed out the swearing and belting the life out of it with a big hammer , seriously, a bit of heat can be usefull doing this job, unless i just happened to pick 3 trucks that where bad to fit them to lol.
j
j
#4
Seasoned Member
Join Date: Jan 2009
Location: FLORIDA
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: I-6
yeah, the cussing and hell raising arent mentioned in the instructons either..lol its easier if you can take out the tie rod, and have everything sitting on the table.. use a heat gun, and PB Blaster, then cuss out your neighbor for being nosey (lol) then it should wiggle off with a little convincing..good luck
#7
CF Veteran
Join Date: Jul 2009
Location: Keesler AFB, MS
Posts: 1,640
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998 XJ
Model: Cherokee
Engine: 4.0L
X2
You always say what i am thinking, maybe i need to pipe up sometimes
I don't really have any info for you, i replaced mine when i added the lift and didn't have the first issue. i could see a BFH working very well though
You always say what i am thinking, maybe i need to pipe up sometimes
I don't really have any info for you, i replaced mine when i added the lift and didn't have the first issue. i could see a BFH working very well though
Thread
Thread Starter
Forum
Replies
Last Post
southfloridajeeps
Modified XJ Cherokee Tech
32
03-04-2023 01:10 PM
aroundincircles
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
10-06-2015 11:12 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)