That happened to my dad, only he didn't realize that's what it was and it killed him.

 

thanks guys, i know i should be waiting to do stuff on the Jeep. but i am going absolutely bat **** crazy not being able to do anything.

 

Put on the rustys











crossmember and transfer case skid plate.

 

I know exactly what you mean! I have ball joints, hubs, and a steering box to replace, but after getting new hip replacements, it's hard to move around.

 

Drove it a lot, up to Paris mountain, to Campbell's covered bridge, to poinsett bridge, and back home without a hiccup.

 

Put a 93 mini console in my 97 daily. Gotta figure out cup holders and my ammo can console mounting now before it goes to its home in my build.

 

Out with the old. In with the Walker QuietFlow stainless steel.

 

Sad thing is i am only 30. My ortho said i was the youngest patient that he has done a full replacement on. but since i plan on going back to school for something i can do as a desk job he agreed to the surgery.

 

I plan to get this muffler also. How does it fit to the short pipe after cat converter, clamp or weld/braze?

 

I just put it on my YJ, but it slipped perfectly over the stock cat output pipe on this application

 

01 has a bubble flare/flange

 

Picked up shackles for the bumpers I just put on my '01, and swapped the newer style cooling system into my '90. Taking them both out to play tomorrow.

 

Sucks having to go through it at an early age. Good thing you have time to bounce back. Best of luck to you!

 

Finished up my fuel pump. Best bang for the buck yet. Way better idle and more *** dyno power.

 

Picked up some rubber for it, 33X10.5s I scored for about a bill each, less than 200mi on em.