Jeep Cherokee Forum - Search Results

 
Search: Posts Made By: 4jeepers
Showing results 1 to 25 of 223
Search took 0.09 seconds.
Replies: 47
Views: 15,847
Posted By 4jeepers

I got an '88

I have an '88 limited! It's the same vehicle with a few doodads!
Replies: 9
Views: 760
Posted By 4jeepers

They are on the left side of the engine under the...

They are on the left side of the engine under the COIL PACK. you have to remove the coil pack, not very hard to do, ( 2 screws, one at each end) The left side of engine looking at it from the front....
Replies: 13
Views: 1,193
Posted By 4jeepers

Exclamation Replace the pump, as long as your going to move...

Replace the pump, as long as your going to move everything to get to the gasket, play it safe! :thumbup:
Replies: 13
Views: 1,490
Posted By 4jeepers

Vent tube should be routed high on frame to keep...

Vent tube should be routed high on frame to keep water out of diff or transfer case.
Replies: 16
Views: 1,372
Posted By 4jeepers

Question Maybe! I am assuming that you are getting brake...

Maybe! I am assuming that you are getting brake fluid to the front brakes. If so, It could be the proportioning valve or the master cylinder itself. :D By the way you have a nice rig!
Replies: 2
Views: 614
Posted By 4jeepers

Exclamation Did you run a check on your fuel pump? Also may...

Did you run a check on your fuel pump? Also may be a good idea to put an OHM meter on the ballast resistor if your vehicle has one! :chef:
Replies: 3
Views: 704
Posted By 4jeepers

Thumbs up X2, Been there and done that, It really works!...

X2, Been there and done that, It really works! :surrender:
Replies: 15
Views: 10,558
Posted By 4jeepers

Exclamation I don't know if the TPS is adjustable on a 1999,...

I don't know if the TPS is adjustable on a 1999, There is an adjustment on my 1988 Renix. Did you just start the vehicle up, or did you take it for a long drive with the new TPS. It takes a while of...
Replies: 15
Views: 1,175
Posted By 4jeepers

Exclamation The voltage output should not be lower than...

The voltage output should not be lower than specs. I read somewhere that 25 percent of replacement parts are defective anyway.
Replies: 9
Views: 837
Posted By 4jeepers

I may be wrong on this, but a quarter inch in and...

I may be wrong on this, but a quarter inch in and out play seems normal as the shaft needs to flex a bit when driving to allow for the movement of the axle so things don't bind and break. That is why...
Replies: 5
Views: 757
Posted By 4jeepers

Exclamation X2, an aftermarket or cheap universal CAT will...

X2, an aftermarket or cheap universal CAT will not pass the visual test. CA. has a list of CAT converters that you can use. The only plus side to this is that if you plan on keeping the vehicle, the...
Replies: 16
Views: 88,031
Posted By 4jeepers

X2, Also when pushing the fitting back in, use a...

X2, Also when pushing the fitting back in, use a little petroleum jelly on the O-Rings to make it install easier. You will hear a click when seated. :thumbup:
Replies: 5
Views: 749
Posted By 4jeepers

Exclamation A new cap is a good idea. However when you were...

A new cap is a good idea. However when you were checking for leaks, did you do something that allowed air to enter the closed system? I would suggest that you let the vehicle cool down and check how...
Replies: 7
Views: 5,004
Posted By 4jeepers

Smile Could be that your two inch lift is actually...

Could be that your two inch lift is actually higher than that. When you lift the vehicle you extend the the distance from the transfer case to the axles causing the drive shaft to pull out some. The...
Replies: 3
Views: 878
Posted By 4jeepers

:thumbup: The filter will be the first thing that...

:thumbup: The filter will be the first thing that you see when the pan is down!
Replies: 7
Views: 5,004
Posted By 4jeepers

Exclamation :icon_sad: The drive shaft yoke should not have...

:icon_sad: The drive shaft yoke should not have any wiggle at the splines. That aside, I think that you should have the drive shaft balanced as the thing had bounced around the ground a few times!...
Replies: 16
Views: 1,628
Posted By 4jeepers

Talking I don't think that its a knuder valve. It looks...

I don't think that its a knuder valve. It looks more like the Panadermic Marzelvane! :thumbup:
Replies: 10
Views: 2,212
Posted By 4jeepers

Exclamation Just a thought! Did you take a good look at your...

Just a thought! Did you take a good look at your Cat. If so equipped!
Replies: 11
Views: 5,903
Posted By 4jeepers

Thumbs up Are you sure that you are not starting my...

Are you sure that you are not starting my Cherokee instead of yours? Mine does the same thing. It starts at about 2200 and drops down after 5 or 6 seconds. TPS adjustment maybe? :stupid:
Replies: 14
Views: 4,715
Posted By 4jeepers

Thumbs up After replacing all those parts it is a good idea...

After replacing all those parts it is a good idea to take a long drive in the vehicle. This will give the ECM time to learn all the new sensors. I do this every time I disconnect the battery as well.
Replies: 23
Views: 2,340
Posted By 4jeepers

Thumbs up :thumbup: I replaced almost every fastener on my...

:thumbup: I replaced almost every fastener on my Jeeps in such a manner and also boosted taco bells profit margin a hundred fold! :head:
Replies: 29
Views: 1,863
Posted By 4jeepers

Exclamation :red_indian: If the Jeep is driving Northbound...

:red_indian: If the Jeep is driving Northbound from Mexico, I think that you can legally seat 24 people! :bangin:
Replies: 14
Views: 1,276
Posted By 4jeepers

X2, I would follow the above answer and not be to...

X2, I would follow the above answer and not be to quick to put transmission fluid into the crankcase. If push comes to shove there are products that are meant for that purpose. I don't like those...
Replies: 4
Views: 2,133
Posted By 4jeepers

:excl: There should be a fitting in that hole,...

:excl: There should be a fitting in that hole, whether pressed in or threaded, I am not sure which. Put a fitting there somehow and a new tube. Make sure that the tube is run high and fastened to the...
Showing results 1 to 25 of 223
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.