Jeep Cherokee Forum - Search Results

 
Search: Posts Made By: SouthSeaPirate
Showing results 1 to 25 of 168
Search took 0.01 seconds.
Replies: 9
Views: 388
Posted By SouthSeaPirate

Thanks, me too. Im going to get a mechanical...

Thanks, me too.
Im going to get a mechanical gauge tomorrow jut to confirm.
May also just change the filter yet again. Maybe draining back. Ill test with a quick of and start to see.

New vids...
Replies: 9
Views: 388
Posted By SouthSeaPirate

Youre on the right path. Turns out it was water...

Youre on the right path. Turns out it was water pump.
First time I removed the belt and checked it it was fine so far as I could tell.
Removed belt again and was very clear what the issue was.
...
Replies: 9
Views: 388
Posted By SouthSeaPirate

About 4 days. Noise and oil pressure issue...

About 4 days. Noise and oil pressure issue started before.
Replies: 9
Views: 388
Posted By SouthSeaPirate

Exclamation 4.0 getting really noisy! Have I killed another one? Videos

Few months ago I put in a 130k mile 98 ZJ engine in my XJ.
New timing chain, sprockets, and gaskets.
No slack in the rods from what I could tell when I had the pan off.

All has been fine for a...
Replies: 10
Views: 390
Posted By SouthSeaPirate

Thanks for the help and ideas guys Looks like...

Thanks for the help and ideas guys
Looks like it was the starter just barely engaging
This little bugger somehow made its way to the solenoid

...
Replies: 10
Views: 390
Posted By SouthSeaPirate

Does it with and without AC But I did tackle...

Does it with and without AC
But I did tackle that first thinking the same.
Pulled clutch and half was rusted. Looks like it hadnt made full contact in some time
Wire brush on angle grinder made...
Replies: 10
Views: 390
Posted By SouthSeaPirate

Sounds like front driver side underhood Lights...

Sounds like front driver side underhood
Lights were deff affected. Just drove with my super brights on and they deff we dimming bad with the noise.

It doesnt sound that loud in the vid but I know...
Replies: 10
Views: 390
Posted By SouthSeaPirate

Nope But that isnt it. It is after a turn and...

Nope
But that isnt it. It is after a turn and is never consistent.
Drove all day today; not once did it make the noise except this morning
And this is new, Ive put thousands of miles on it.
No...
Replies: 10
Views: 390
Posted By SouthSeaPirate

Popping or Chipping noises on Accel, after turn?!

Ok, to start, Jeep has always had a sluggish start sometimes. This issue is new and doesn't seem to correlate.

Basically a couple of weeks ago I started getting belt squeal on cold start. Goes ...
Replies: 6
Views: 406
Posted By SouthSeaPirate

Double sided tape lasted two days before it...

Double sided tape lasted two days before it started coming up :(
Replies: 7
Views: 395
Posted By SouthSeaPirate

Question A-Pillar Plastic and Tabs Keep Breaking

The cheap Chrysler job done on these pillars is ridiculous!
Apparently they simply melt the plastic to hold the tabs.
This has been broken since Ive had my XJ.

Ive tried putting the tabs back on...
Replies: 16
Views: 4,217
Posted By SouthSeaPirate

Yeah, look at my post above explaining (trying to...

Yeah, look at my post above explaining (trying to explain) the rate
Replies: 5
Views: 475
Posted By SouthSeaPirate

Have you taken needles off without issue? I...

Have you taken needles off without issue?
I hear some ppl had major problems with calibration after removal.



You OBS guys have it easier :clover:
Replies: 5
Views: 475
Posted By SouthSeaPirate

Yes, I am aware of this. Doesnt answer any...

Yes, I am aware of this.
Doesnt answer any questions
Note mine is the NBS cluster that has clear needles
Replies: 5
Views: 475
Posted By SouthSeaPirate

Question ~ 97+ cluster needle restoration and LED questions ~

Hi all,
I have an 01' with faded needles, they are pretty much white.
From what I can tell, the needles are clear and the paint is on the bottom.
That said, are the needles removable and what's...
Replies: 16
Views: 4,217
Posted By SouthSeaPirate

Very strange, never has it once ever made the...

Very strange, never has it once ever made the noise using the turns or hazzards. Only 70+ MPH.
Doesnt sound like that.
Also, it doesnt buzz at that rate. As fast as you can read; bzzz, bzz, bz ,bz,...
Replies: 8
Views: 279
Posted By SouthSeaPirate

You have PM

You have PM
Replies: 3
Views: 220
Posted By SouthSeaPirate

Are you saying the fan does not kick on when...

Are you saying the fan does not kick on when overheating?

Otherwise fan operation isnt exactly consistent. Has to be at a certain temp with and without AC
Replies: 3
Views: 213
Posted By SouthSeaPirate

Yep, noise suppression for the coil pack. To keep...

Yep, noise suppression for the coil pack. To keep static out of the radio or CB's etc
Replies: 3
Views: 213
Posted By SouthSeaPirate

Thanks! Researching now Just found an old...

Thanks! Researching now

Just found an old pic of it on the old stock block.

http://www.clickover.com/images/s_3/2017_07_22_1_c6d45763c30928586516.jpg
Replies: 1
Views: 262
Posted By SouthSeaPirate

From 93 manual, might help. LMK 16 - 30 Amp...

From 93 manual, might help. LMK

16 - 30 Amp (Circuit Breaker)
Power Seats, Trailer Tow.

...
Replies: 16
Views: 4,217
Posted By SouthSeaPirate

kind of like this ...

kind of like this

https://www.youtube.com/watch?v=UHptq5eBeNI
Showing results 1 to 25 of 168
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.