Jeep Cherokee Forum - Search Results

 
Search: Posts Made By: 4.3L XJ
Showing results 1 to 25 of 496
Search took 0.07 seconds.
Replies: 2
Views: 147
Posted By 4.3L XJ

No, it will not run if there is no pressure in...

No, it will not run if there is no pressure in it. There is an in line switch called a low pressure limit switch that interrupts the circuit from the dash to turn on the compressor
Replies: 7
Views: 234
Posted By 4.3L XJ

Hold everything, was that port on the large line...

Hold everything, was that port on the large line or small one?
06-17-2019, 05:09 PM
Replies: 48
Views: 5,421
Posted By 4.3L XJ

I think there is one issue about this that hasn't...

I think there is one issue about this that hasn't been discussed. The reason for the vents. So to add to this concept, when lifting a Jeep the air pressure in the engine compartment goes up a...
06-16-2019, 03:57 PM
Replies: 0
Views: 329
Posted By 4.3L XJ

Dana Super 44

Here is a question for the well informed. Tried contacting Eaton on this, but I am not a wholesaler, so no go on that. I am building front and rear D44s for the XJ. So they have a 33 spline...
06-16-2019, 03:44 PM
Replies: 7
Views: 540
Posted By 4.3L XJ

Mine has a Chevy engine, so I have the type one...

Mine has a Chevy engine, so I have the type one pump. You have the type 2. Those can be used with the stock reservoir or with a remote
Replies: 4
Views: 266
Posted By 4.3L XJ

The bolt pattern on the Rubicon up to when the JK...

The bolt pattern on the Rubicon up to when the JK model debued in 07 will fit. If they are for the 07 and up Rubicon, those are 5X5 pattern and will not fit without an adapter
06-15-2019, 04:02 PM
Replies: 7
Views: 540
Posted By 4.3L XJ

I have the AGR version. I like it, makes the...

I have the AGR version. I like it, makes the steering a little easier and it makes 40% more push in the box.
06-11-2019, 08:20 PM
Replies: 5
Views: 430
Posted By 4.3L XJ

Did you use super heat or sub cooling to charge...

Did you use super heat or sub cooling to charge it? With a TXV you have to use subcooling (difference between measured heat after the condenser vs pressure?temp n the gauges. You cannot measure the...
06-11-2019, 07:10 PM
Replies: 5
Views: 430
Posted By 4.3L XJ

Does this system that has a TXV also have a sight...

Does this system that has a TXV also have a sight glass?
Replies: 4
Views: 235
Posted By 4.3L XJ

No. But if you have bad axle shaft U joints it...

No. But if you have bad axle shaft U joints it can contribute to it
06-04-2019, 07:16 PM
Replies: 12
Views: 843
Posted By 4.3L XJ

You are all right. Immediate gratification on...

You are all right. Immediate gratification on faceplant and others has taken the users away from most forums. That and all of us old timers used computers to access this stuff. Now everyone does...
05-31-2019, 01:43 PM
Replies: 27
Views: 1,848
Posted By 4.3L XJ

I am liking this build. An exo cage is not...

I am liking this build. An exo cage is not something I would want to be having on all the time, but when I hit the rocks it would definitely be a plus for our fragile bodies.
Replies: 22
Views: 1,000
Posted By 4.3L XJ

I think the best way to fix that is with Brown...

I think the best way to fix that is with Brown Dog motor mounts. They use more bolt holes in the block so are stronger
Replies: 3
Views: 627
Posted By 4.3L XJ

Mine is carbon steel metal and has a nice little...

Mine is carbon steel metal and has a nice little white handle on it
Replies: 8
Views: 485
Posted By 4.3L XJ

No, that is the point of a bastard pack, or add a...

No, that is the point of a bastard pack, or add a leaf depending on how you look at it. Your current springs still have arch to them, just not as much as new. Likely you only need to add one leaf. ...
Replies: 3
Views: 627
Posted By 4.3L XJ

I don't know for sure, but the 04 uses a spike...

I don't know for sure, but the 04 uses a spike tool to move the tab in and the connector comes out the front. There is also a piece that comes off the back so you can access them. I have done lots...
Replies: 8
Views: 485
Posted By 4.3L XJ

Vehicles that have leaf springs that are fairly...

Vehicles that have leaf springs that are fairly soft and flex a lot as a matter of normal driving, like the XJ have these problems. The leaves loose their temper over time and use. After you get it...
05-22-2019, 10:47 AM
Replies: 9
Views: 1,700
Posted By 4.3L XJ

The guy you want to ask about that is on another...

The guy you want to ask about that is on another forum, XJTalk. He runs hams and knows about them. Contact Mudderoy on that forum
05-17-2019, 05:44 PM
Replies: 4
Views: 341
Posted By 4.3L XJ

I have had lots of Fords and ford solenoids. ...

I have had lots of Fords and ford solenoids. This would be a good suggestion on a different vehicle. But the starter relay only powers a larger relay (starter solenoid) on the starter. However you...
Replies: 1
Views: 264
Posted By 4.3L XJ

Those look like Contura V switches. I have a...

Those look like Contura V switches. I have a bunch of them in my Jeep and the cool thing is those rockers are easily replaceable. This guy sells the rockers and hole switches with a bunch of cool...
05-17-2019, 11:42 AM
Replies: 4
Views: 341
Posted By 4.3L XJ

Does it start with the tranny in neutral?

Does it start with the tranny in neutral?
Replies: 2
Views: 307
Posted By 4.3L XJ

Do you have any of that old coolant left? If so,...

Do you have any of that old coolant left? If so, take it to a radiator shop and have it tested for exhaust gasses. If it has them in it, you have a blown head gasket and you will have to replace it...
Replies: 6
Views: 364
Posted By 4.3L XJ

Have you looked under it while someone else saws...

Have you looked under it while someone else saws the steering wheel back and forth? Any loose joints will be apparent
05-10-2019, 01:38 PM
Replies: 10
Views: 652
Posted By 4.3L XJ

If you are swapping from a D35, then no. You can...

If you are swapping from a D35, then no. You can get a Spicer 1310 yoke for it if doesn't have one and use your old shaft. Otherwise you can use an adapter 1310/1330 U joint
Showing results 1 to 25 of 496
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.