Jeep Cherokee Forum - Search Results

Go Back  Jeep Cherokee Forum > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Tsaani97xj
Showing results 1 to 25 of 493
Search took 0.04 seconds.
02-23-2019, 06:02 PM
Replies: 9
Views: 602
Posted By Tsaani97xj

Keep in mind almost all 3" coils are super heavy...

Keep in mind almost all 3" coils are super heavy spring rate in the 240# range. Except Rusty's and RC. Stock spring rate is 147#. If you're set on 3" springs stay with Rusty's. The rest of your plan...
Replies: 5
Views: 411
Posted By Tsaani97xj

When ethanol sits and contacts water it gells up....

When ethanol sits and contacts water it gells up. At least that is how it was explained to me. Big problem for marine engines.
12-14-2018, 02:05 PM
Replies: 5
Views: 494
Posted By Tsaani97xj

https://jksmfg.com/i-9056829-cherokee-xj-comanche-...

https://jksmfg.com/i-9056829-cherokee-xj-comanche-mj-1984-2001-front-adjustable-coil-spacer.html

Nothing wrong with coil spacers 2" and under. IMO.

The ACOS linked here are a nice option if...
11-30-2018, 10:40 AM
Replies: 13
Views: 1,046
Posted By Tsaani97xj

You need more weight up front or new springs,...

You need more weight up front or new springs, control arm drop brackets, shackle relocation boxes.

RE 3.5" springs like a lot of the 3" springs have a very high spring rate @~240lbs where stock...
11-25-2018, 09:05 AM
Replies: 29
Views: 2,021
Posted By Tsaani97xj

Treadwright aren't retreads they are remolds. The...

Treadwright aren't retreads they are remolds. The whole casing gets new rubber. I had no issues running them.
11-23-2018, 12:41 PM
Replies: 11
Views: 573
Posted By Tsaani97xj

Dropping the cross member will put stress on the...

Dropping the cross member will put stress on the motor mounts and cause potentially faster wear. I found using thick washers and new bolts worked well to adjust the drop just as much as it takes to...
10-17-2018, 12:58 PM
Replies: 2
Views: 424
Posted By Tsaani97xj

Stock shackles will lower it some for sure....

Stock shackles will lower it some for sure. Better but slightly more money would be shackle relocation boxes. They are a huge boost to how your leafs perform.
10-06-2018, 06:44 AM
Replies: 6
Views: 793
Posted By Tsaani97xj

Sorry to say your Jeep's not sophisticated enough...

Sorry to say your Jeep's not sophisticated enough to do this. The computer doesn't control all of the vehicles features like newer ones.
09-21-2018, 01:13 PM
Replies: 1
Views: 350
Posted By Tsaani97xj

Looks close from here but if RE 5.5s are like the...

Looks close from here but if RE 5.5s are like the rest of their stuff you've probably got 6.5-7" of lift.
08-09-2018, 03:12 PM
Replies: 17
Views: 1,470
Posted By Tsaani97xj

I would have to think you have something else...

I would have to think you have something else going on making the ride stiff. RE 4.5" springs have a good spring rate ~184lbs. They rode really nice with CADs and Bilsteins.
08-07-2018, 08:01 AM
Replies: 28
Views: 887
Posted By Tsaani97xj

Does that track bar bracket on the frame attach...

Does that track bar bracket on the frame attach on the side anywhere? Cant see any bolt in those pics. I would imagine if it doesnt that could be your problem. One direction is going to push it in to...
06-28-2018, 05:41 PM
Replies: 35
Views: 9,553
Posted By Tsaani97xj

Wow old thread revival haha. As to my earlier...

Wow old thread revival haha. As to my earlier post and correction I ended up having to flip the shims because at 5"+ the ujoints would bind. Id like to retract and state shim installation depends on...
06-05-2018, 05:28 PM
Replies: 9
Views: 4,078
Posted By Tsaani97xj

Because the faster the alternator spins the more...

Because the faster the alternator spins the more power it puts out. The regulator keeps it at 13.8. A smaller pulley would up the idle power. I wouldn't worry about it.
Replies: 2
Views: 185
Posted By Tsaani97xj

Is your AC or Defrost on? The aux fan runs when...

Is your AC or Defrost on? The aux fan runs when the AC compressor comes on in either of those modes. If this is the case you likely need the system recharged, after checking for leaks.
05-03-2018, 01:05 PM
Replies: 7
Views: 464
Posted By Tsaani97xj

https://hdoffroadengineering.myshopify.com/ ...

https://hdoffroadengineering.myshopify.com/

This is usually the go to around here. Have no experience with what you linked but have used the standard bolt on brackets from HD and they are good.
04-21-2018, 10:49 AM
Replies: 4
Views: 393
Posted By Tsaani97xj

Instead of limiting the front you could increase...

Instead of limiting the front you could increase the rear flex. Leaf springs have been around forever and have been used on very capable rigs. The factory shackle system is very limiting but you can...
04-20-2018, 09:35 AM
Replies: 21
Views: 621
Posted By Tsaani97xj

No difference how the tach reads as far as I...

No difference how the tach reads as far as I know. I swapped the lights to full gauge cluster on a 97 ax15 and had no issues. 4000 rpm on the 4.0 is screaming. Redlines close to 5k iirc. 2500-3000 is...
04-18-2018, 02:51 PM
Replies: 5
Views: 373
Posted By Tsaani97xj

Keep what you have but I would add CADs ( control...

Keep what you have but I would add CADs ( control arm drop brackets ), shackle relocation kit and an IRO double shear track bar. You will have improved everything, handling, ride, flex. If you feel...
04-04-2018, 12:30 PM
Replies: 27
Views: 2,384
Posted By Tsaani97xj

I agree with others. Do not accept that if at all...

I agree with others. Do not accept that if at all possible. I definitely wouldnt trust those springs matched like that. For a temporary thing sure use it.
03-29-2018, 07:21 PM
Replies: 8
Views: 496
Posted By Tsaani97xj

Maybe check the wiring between the kick panel and...

Maybe check the wiring between the kick panel and door. Might have exposed wires shorting to ground which I think is what the door position switch does. Vibrations from driving, operating the window...
03-28-2018, 07:39 PM
Replies: 6
Views: 306
Posted By Tsaani97xj

You want to keep the main s10 leaf. Mess with...

You want to keep the main s10 leaf. Mess with other combinations to get your height. Bastard packs are cheap till you have to redo them a few times to get it right. Shackle relocation boxes can help...
03-27-2018, 10:50 AM
Replies: 35
Views: 3,106
Posted By Tsaani97xj

Sounds like a solid plan. I ran 5.5/5" of lift on...

Sounds like a solid plan. I ran 5.5/5" of lift on 31s, stock wheels and fender flares. It looked just fine, lots of compliments. The two things I would strongly recommend are control arm drop...
03-13-2018, 07:28 PM
Replies: 14
Views: 1,085
Posted By Tsaani97xj

Get the hydros. The Zone coils are way stiffer...

Get the hydros. The Zone coils are way stiffer than the RC ones you have. Stiffer shocks wont help. Now saying that the Bilsteins, to me anyways, make the ride much more controlled feeling, good...
03-13-2018, 07:22 PM
Replies: 36
Views: 1,594
Posted By Tsaani97xj

I was on 5.5/5" with RE coils, s10 bastard,...

I was on 5.5/5" with RE coils, s10 bastard, relocation boxes, RockyRoad cads, oem control arms, 5100s, JKS rear xover shock mount in the rear and it handled as good as stock and rode better. Its all...
01-30-2018, 07:08 PM
Replies: 62
Views: 6,217
Posted By Tsaani97xj

From the last response it is the new springs and...

From the last response it is the new springs and shocks. Almost all 3" lift springs have obnoxious spring rates over 220lbs. Stock is 147lbs. Add the stiffer shocks and a more steep control arm angle...
Showing results 1 to 25 of 493
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.