New from pa
Trending Topics
12-03-2014, 04:58 PM
#10
Member
Join Date: Aug 2013
Location: Arizona
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L I6
12-03-2014, 10:31 PM
#11
Newbie
Thread Starter
Join Date: Nov 2014
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Haha yea first time out for her. No rattle can - I used a 1.8 tip on an hvlp gun at 45psi. The paint is Parker duck boat desert tan.
12-03-2014, 10:38 PM
#12
Seasoned Member
Join Date: May 2013
Location: North Atlantic - Delaware
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: Inline 6 4.0
Nice color 
. Ps is your antenna on the driver side stock? I've never seen that before. Usually it's always on the passenger side.
. Ps is your antenna on the driver side stock? I've never seen that before. Usually it's always on the passenger side.
12-04-2014, 06:23 AM
#13
Newbie
Thread Starter
Join Date: Nov 2014
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
That is not stock - it's actually my cb antenna. I put the mount in under the fender against the upper support rail (got a standard 1"x4" flat mount and bent it at a right angle then used nutserts to mount to the upper rail and slid under a cut I made in the fender where it's screwed in to the upper rail) then cut a hole in the fender mimicking the oem antenna location on the other side and put trim guard around the hole to keep the antenna mount nut isolated. Took a lot of adjusting but it sits at the exact angle the oem antenna does on the other side. None of the actual antenna goes through the fender either, so I can easily unscrew it for garages and stuff.
12-04-2014, 07:33 AM
#14
Seasoned Member
Join Date: May 2013
Location: North Atlantic - Delaware
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: Inline 6 4.0
That is not stock - it's actually my cb antenna. I put the mount in under the fender against the upper support rail (got a standard 1"x4" flat mount and bent it at a right angle then used nutserts to mount to the upper rail and slid under a cut I made in the fender where it's screwed in to the upper rail) then cut a hole in the fender mimicking the oem antenna location on the other side and put trim guard around the hole to keep the antenna mount nut isolated. Took a lot of adjusting but it sits at the exact angle the oem antenna does on the other side. None of the actual antenna goes through the fender either, so I can easily unscrew it for garages and stuff.