JeepXJExpo

Rebuilding my 99 XJ so I am selling the following. All located in Blacksburg VA.


5 x 35x12.50R15 Tires - General AT tires. One has small bubble in sidewall that was there from mounting it wrong by the shop. I has not gotten any bigger in 2 years and I ran it just fine before moving to the spare. Only about 1000 road miles on them in 3 years as it's a garage kept trail vehicle. Tread is great and probably 85% left at least. Balances fine.



Black ProComp wheels with 4.5 backspacing look great, but some have some minor rock rash but nothing major at all. 5x4.5 backspacing.



$850 for tires mounted on wheels.


Built Dana 30 HP and 8.25 Axles -
Putting new axles under my Jeep so selling current set. Just got back from Black Mountain and like always, they did awesome. This is currently under a Jeep XJ but will fit other Jeeps and can be made to fit other vehicles as well.



-> HP Dana 30 with over the knuckle 1-ton steering from JCR.

Yukon 4.56 gears with Aussie locker.

Chromoly shafts and stock shafts come with it as spares.

New inner seals recently and outer seals as well.

Alloy USA ball joints.

Lower control arm mount guards welded on.

Small truss on it as well as G2 cover.

New calipers and brakes installed within the last year as well on front and new wheel bearings on both sides with replacements still here as spares (can never have too many spares parts for an offroad rig)



Here is a parts list for JUST the front axle:

-New Brakes and Calipers ~ $100

-Alloy USA Ball Joints $199

-Aussie Locker $259

-Chromoly Shafts $490

-Outer Tube Seals $50

-Ring and Pinion $130

-G2 Cover $119

-Control Arm Mount Skid plates $50

-1 Ton OTK steering $390

(misses other items like seals and truss) This alone comes to $1,417 WITHOUT any labor to install or the axle housing itself!



-> Rear 8.25 with 4.56 gears and Powertrax locker.

Chromoly shafts and stock shafts come as spares.

Also have Ruffstuff cover and truss (not installed) that goes with it.

New drum brakes installed this year with wheel cylinders and everything


$1800 for the set. Ready to go!


Rubicon Express Control Arm Drop Brackets and Supports - drop brackets installed and used but the supports that go back and bolt to the "frame" have never been used


Drop brackets are $177 new and supports are $78. I'll take $150 for the pair