Mark this thread as Unsold
[FS] Custom Cowl Intake Snorkel
#1
Custom Cowl Intake Snorkel
I designed and built this custom Cowl Intake Snorkel, and installed it once to take pictures of the install.
I sold my XJ, and never used it.
I never ran the engine with it installed. (it would not fit mine due to the drip trays for the Camaro Hood-louvers. It would have contacted them when closing the hood)
It is designed for my '96, but would fit any H.O. 4.0 XJ.
I designed and built it out of ABS plastic, with heat shielding where it crosses the engine, and uses a K&N filter.
It is designed to use the factory Throttle-Body Elbow (turned to face the other way), and the factory Crankcase Breather Tube, without modification.
I requires re-locating a vacuum solenoid, cutting an oval-shaped hole into the wiper-cowl area from the engine side, and cutting an access hole into the wiper-cowl area from the top.
I am selling it for $100.00-shipped to the lower 48 states, and will include detailed instructions for re-locating the solenoid, and measurements for cutting the access holes into the wiper-cowl.
I sold my XJ, and never used it.
I never ran the engine with it installed. (it would not fit mine due to the drip trays for the Camaro Hood-louvers. It would have contacted them when closing the hood)
It is designed for my '96, but would fit any H.O. 4.0 XJ.
I designed and built it out of ABS plastic, with heat shielding where it crosses the engine, and uses a K&N filter.
It is designed to use the factory Throttle-Body Elbow (turned to face the other way), and the factory Crankcase Breather Tube, without modification.
I requires re-locating a vacuum solenoid, cutting an oval-shaped hole into the wiper-cowl area from the engine side, and cutting an access hole into the wiper-cowl area from the top.
I am selling it for $100.00-shipped to the lower 48 states, and will include detailed instructions for re-locating the solenoid, and measurements for cutting the access holes into the wiper-cowl.