Mark this thread as Unsold
FS[PacNorWest]: Stock axles, '93 XJ
#1
Seasoned Member
Thread Starter
Join Date: Jun 2010
Location: Central Washington
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
Year: 91 xj, 93 xj, 93 zj, 94 zj
Model: Cherokee
Engine: 2x I6, 2x v8
Stock axles, '93 XJ
Set of stock axles from a 1993 Cherokee XJ, came from same vehicle, freshly pulled Memorial Day Weekend.
Front is Dana 30, complete from disk to disk. Brake pads and rotors still have some life. Ill part out, however axle shafts will be last to go (trail spares unless the whole axle sells). Does not come with vent tube (stayed with vehicle). This is NOT a vacuum disconnect axle.
Rear is Chrysler 8.25, assumed 27 spline. Complete drum to drum minus vent tube riser and shock mounts. Will part out. I have aftermarket shock mount tabs that were removed from the axle that replaced this one that should work with this one with a little clean up.
Gear ratio is stock for '93 I6, AW4 trans, assumed to be 3.55 -- http://www.jeepforum.com/forum/f11/c...k-specs-26256/
I am interested in trades (look at my other listings). As mentioned above, I can still use the axle shafts (and brakes) on the front axle, and these are last to go if I do part the axle out.
I also have another Dana 30 front axle housing out of a Wrangler, completely stripped, if anyone is interested in it.
UPDATE: long side axle shaft inner and outer sold from front axle.
Front is Dana 30, complete from disk to disk. Brake pads and rotors still have some life. Ill part out, however axle shafts will be last to go (trail spares unless the whole axle sells). Does not come with vent tube (stayed with vehicle). This is NOT a vacuum disconnect axle.
Rear is Chrysler 8.25, assumed 27 spline. Complete drum to drum minus vent tube riser and shock mounts. Will part out. I have aftermarket shock mount tabs that were removed from the axle that replaced this one that should work with this one with a little clean up.
Gear ratio is stock for '93 I6, AW4 trans, assumed to be 3.55 -- http://www.jeepforum.com/forum/f11/c...k-specs-26256/
I am interested in trades (look at my other listings). As mentioned above, I can still use the axle shafts (and brakes) on the front axle, and these are last to go if I do part the axle out.
I also have another Dana 30 front axle housing out of a Wrangler, completely stripped, if anyone is interested in it.
UPDATE: long side axle shaft inner and outer sold from front axle.
Last edited by TrollHammer; 01-05-2015 at 05:52 PM.
Thread
Thread Starter
Forum
Replies
Last Post
nicksan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
28
03-08-2016 11:33 AM
aa7kn
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-23-2015 09:08 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)