IRO Long Arm, Ford 8.8, HP D30, 4.10 gears ect, ect, ect
 

I have a 2000 Jeep Cherokee Roller with no motor or tranny in it. The Jeep has the following parts with NO miles driven on them just installed.

I want to sell it as a roller.

4" Iron Rock Offroad Lift with rear add a leafs

HD Offroad Shackle relocators

Brand new brake lines from master to rotors with new extended soft lines,

Ford 8.8 with 4.10 gears, limited slip and disk brakes
-New parking brake shoes with hardware kit, rotors, and pads
-New brake lines ran over axle, with new soft lines on the axle
-Filled with mobile 1 synthtic gear oil with limited slip additive
- Rear axle has been swapped into the Cherokee and has had the spring
perches welded in and the pinion angle set.

HP Dana 30 with 4.10 gears
-Good unit bearings
-New front rotor and pads

JCR nut strips


I want to sell whats left as a roller, I do not want to part it out I jut figured this is the best place to post it for sale.

Will trade for a nice 18ft or 20ft car trailer.

$1800 O.B.O

Wrong section. I just moved this to vehicles for sale.

Didn't think vehicles for sale was the correct section since it's missing a motor and tranny.

since you are selling a whole shell with parts on it and u refuse to part it out... Then yes it belong here.

Pics? What's the rust situation like?

There whole jeep was Ziebart rust proofed. There is some rust though. There are a few small 1" by 1" rust though spots behind the front fender liner, the passenger side rear unibody rail over the rear axle was rusted and a new piece taken out of another cherokee was welded in. The rest is solid.

That is all the real pics I have of the Jeep. I will have to get more if someone wants them.

Attachment 313108

Attachment 313109

its still for sale. I will trade for a good car trailer.

This looks like a good roller for someone with a nice engine and trans to throw in.