Mark this thread as Unsold
FS[MidAtl]: 98 xj built, low miles.
09-11-2017, 06:02 PM
#1
Member
Thread Starter
Join Date: May 2011
Location: Jim Thorpe PA
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Engine: 4.0
98 xj built, low miles.
Want to sell my 98 xj, it has 97k and is pretty much fully built, next step would be linking the rear on coils and caging if I were to keep it. Its just too impractical as it as for what i would use it for and does nothing but sit in the garage.
Front axle. D44 from a 79 bronco, re-tubed, reid knuckles, chromo shafts, Detroit locker, 4:88 gears, warn lockout hubs with grade 8 hardware.
Rear axle, 9in from 79 bronco, shaved, back braced, pinion skid, 35 spline Moser hobby stock axles, Detroit locker
Motor, Spectre cowl snorkle, stock otherwise
Trans: rebuilt aw4
Transfer case: np231 upgraded main shaft and chain, sye kit, boostwerks linkage
Miscellaneous: front winch bumper with warn 10k, rear tire carrier bumper with hitch, rockers cutout and replaced with box steel tied to frame rails, diy beadlocks on procomp wheels. 35in km2's with 90% tread, fully plated frame rails, steering box tapped for hydro assist ram, one ton otk steering with hydro assist, on board air system.
Needs, front u-joints, front axle seals, neutral safety switch.
Looking for $5000. Would trade for a clean stock xj or mj plus cash.
Send me your number so I can text pictures since Photobucket sucks anymore.
Front axle. D44 from a 79 bronco, re-tubed, reid knuckles, chromo shafts, Detroit locker, 4:88 gears, warn lockout hubs with grade 8 hardware.
Rear axle, 9in from 79 bronco, shaved, back braced, pinion skid, 35 spline Moser hobby stock axles, Detroit locker
Motor, Spectre cowl snorkle, stock otherwise
Trans: rebuilt aw4
Transfer case: np231 upgraded main shaft and chain, sye kit, boostwerks linkage
Miscellaneous: front winch bumper with warn 10k, rear tire carrier bumper with hitch, rockers cutout and replaced with box steel tied to frame rails, diy beadlocks on procomp wheels. 35in km2's with 90% tread, fully plated frame rails, steering box tapped for hydro assist ram, one ton otk steering with hydro assist, on board air system.
Needs, front u-joints, front axle seals, neutral safety switch.
Looking for $5000. Would trade for a clean stock xj or mj plus cash.
Send me your number so I can text pictures since Photobucket sucks anymore.
