2001 XJ Crawler FS
For Sale: $8000 obo
Willing to consider trades for something on Tons! 2001 Jeep Cherokee XJ Sport 199,000+ miles Original Motor (4.0L I6 High Output, 225 ft lb torque @ 3000 rpm) Original Head still going strong Automatic (AW4 Transmission) NP-231 T-case (2.72:1 ratio low range, 1” T-Case Drop/No SYE) California Emissions (two Catalytic Converters) Clean and Clear Title Registered in New Mexico Easily Passes emissions This is a not a show queen. Solid daily driver AND she can do it off road, too. Keeps up with JKs, TJs, and LJs on 37’s. NO RUST! Driven it to Moab twice, Colorado twice, Baja once, and all over New Mexico, as well as used it as a daily driver. Trails done Moab- Kane Creek Steel Bender Strike Ravine and many more (already registered for Moab Rim, Cliffhanger and Golden Spike this year!) Buena Vista- Iron Chest Holy Cross City Black Bear Chinaman’s Mt. Blanca Chile Challenge- Backstage Pass Lost Boys The Narrows This is a solid rig ready to go. Build List - Nates 4x4 Front Bumper Bulldog 6000lbs wired winch 5.5” Rubicon Express Short Arm Lift with Drop Brackets (including HD track bar, Track Bar mount, and brace) 1” pucks on Front end for 6.5” total Bastard Pack Rear Leaf Spring set-up on rear Iron Man Andy Shackle Relocators Rear JKS 6” Boomerang Shackles 1” Axle Shim pack on rear for 7+ inches of lift Extended Brake Lines (front and rear) Bilstein 5100’s all around (rear = New March 2015, right front = Aug. 2015) Steering box brace Custom Built Swing away tailgate with spare tire mount Full Size spare tire (Wrangler MTR) 35” Wrangler MTR’s (left rear = brand new (less than 100 miles) right rear less than 1000 miles. Front and spare = 40% tread life)) 15 inch faux beadlock rims (last two times they had to cut the tire off!) Custom Roll Cage (A/B/C pillar) installed by Steel Lizard Detours Rock Slyders/Frame Stiffeners JCR Gas Tank Skid New Fuel pump and seal (March 2015) New Oil Pan Gasket (Nov. 2015) New Rear Main Seal (Nov. 2015) New Melling High Volume Oil Pump (Nov. 2015) Eaton E-Locker in front- professionally installed by New Mexico Gear and Clutch (Nov. 2015) Ox Locker w/Electric Actuator in rear - professionally installed by New Mexico Gear and Clutch (May 2016) IronRockOffroad Tie Rod (Nov. 2015) Curry Currectlync DragLink (Nov. 2016) Flowmaster Muffler Fully Rhino-Lined Tub Fully soundproofed tub with Fatmat Fully carpeted tub Built in Toolbox drawers in trunk On board air (Viair 400H) LubeLocker Diff Seals (Aug. 2015) Hood Louvres for engine cooling 62mm Throttle Body Spacer with Vortex funneling Cold Air intake w/K&N Filter Firestik 48” antenna Tinted Windows JKS Quick Disconnect front sway bar Rear Sway bar removed Optima Yellow Top Battery (New Aug 2016) Auxiliary relay box (Nov. 2015) Custom Built SPOD Switch Box with OTRATTW switches (Nov. 2015) Pioneer aftermarket Stereo/CD/Aux New CPS (Nov. 2015) Comp Cut rear Fenders for extra clearance in boulder fields Rear Seat Upper ZJ swap so has headrests in back seat Front Axle Build - Rebuilt High Pinion Dana 30 Axle ( Nov. 2015) Trussed (Artec) Gusseted (Artec) Johnny Joints Passenger Side Sway Bar Relocation Bracket (Synergy) New 4.56 Ring and Pinion (Alloy USA, Nov. 2015) installed by New Mexico Gear and Clutch New Carrier and Pinion Bearings (Timken, Nov. 2015) New Ball Joints (Synergy, Nov. 2015) New Oil Pan Gasket (Felpro, Nov. 2015) New Rear Main Seal (Felpro, Nov. 2015) Ruff Stuff Front Diff Cover (Nov. 2015) Eaton E-Locker (Nov. 2015) New Inner Axle seals (Timken, Nov. 2015) New LubeLocker Diff seal (Nov. 2015) Chrysler 8.25 rear Axle New Seals (Timken inner and outer) (May 2016) Ox Locker with 4.56 gearing installed by New Mexico Gear and Clutch Spare axle shafts for front. I also have almost everything needed for a full WJ knuckle and brake swap (minus lower ball joints), plus everything needed for a ZJ rear Disc Brake conversion. Also have ring seal for oil filter adapter. Also have two aftermarket front seats I’ll throw in. The Bad: Airbag light is on (has passed inspection twice like this!). Windshield Wiper reservoir has a crack and leaks. Crossmember and muffler have impact damage, but still fully functional. Two cracks in the trans tunnel: just need to be drilled and welded (haven’t had time). Right Rear tail light is broken on outside; still functional/legal. A/C has been deleted. Because no SYE, slight shudder at 15-18MPH, but otherwise runs great. Will deliver with $1000 down within 6 hours of ABQ (Phoenix/Denver/Amarillo/Moab, etc). For Full Asking up front, will deliver within 12 hours (OKC/Las Vegas/SLC/San Diego/LA/Kansas City/Dallas/Rapid City, etc) For an extra $1000 will install SYE with Tom Woods shaft, remove T-Case Drop, install WJ swap on front, discs on rear, and will rattle can everything yellow and/or purple to black. https://cimg7.ibsrv.net/gimg/www.che...2308787fee.jpg https://cimg8.ibsrv.net/gimg/www.che...d47fe98b73.jpg https://cimg9.ibsrv.net/gimg/www.che...6746748506.jpg https://cimg9.ibsrv.net/gimg/www.che...8f9369f8e1.jpg https://cimg0.ibsrv.net/gimg/www.che...f916658529.jpg https://cimg2.ibsrv.net/gimg/www.che...4b6ea72bd9.jpg https://cimg3.ibsrv.net/gimg/www.che...f78801b276.jpg https://cimg5.ibsrv.net/gimg/www.che...b2edc20a1f.jpg https://cimg7.ibsrv.net/gimg/www.che...6db010a99f.jpg https://cimg8.ibsrv.net/gimg/www.che...5497819dd9.jpg https://cimg9.ibsrv.net/gimg/www.che...2da198fc26.jpg https://cimg0.ibsrv.net/gimg/www.che...7837479b4e.jpg https://cimg2.ibsrv.net/gimg/www.che...73065f7d49.jpg https://cimg3.ibsrv.net/gimg/www.che...894fcc8cd1.jpg https://cimg4.ibsrv.net/gimg/www.che...eee2a21818.jpg https://cimg5.ibsrv.net/gimg/www.che...3a52187c2f.jpg https://cimg7.ibsrv.net/gimg/www.che...9f778d6c38.jpg https://cimg8.ibsrv.net/gimg/www.che...7a718117c5.jpg |
All times are GMT -5. The time now is 11:15 PM. |
© 2024 MH Sub I, LLC dba Internet Brands