1998 5-Speed Red Cherokee Sport
I have a 1998 Jeep Cherokee in very good condition I rebuilt it from the ground up and painted everything I replaced or repaired. It has 177,000 miles on the motor 225,000 on the transmission, axles, and body, a 3 inch BDS suspension lift with Rough Country track bar, lower control arms and the front pinion angle has been corrected with custom uppers to account for lift. The entire brake system had been replaced with stainless steel lines. I used POR-15 and Bed liner on almost everything and the Jeep has next to no rust, as it is very clean and I have taken good care of it. Axles are stock HP Dana 30 and Chrysler 8.25 29 spline. Tires are 31 inch Wranglers with less then 7,000 miles on them. I am selling the Jeep to help pay for college. I am asking $7000, I drive back and forth from California and Michigan now and then so I can possibly deliver, in either state or not to far out of the way. Title is clean and I have a file with receipts of almost all major purchases.
History on the vehicle is the owner before me I went to college with and he daily drove it to and from his internship and home. I have had it for a little over a year now and I just registered it a few weeks ago for the first time since the rebuild. I recently took it up north for the first time to do some trail riding and it handled very well! Please text/comment with any questions you have thank you. (858-213-659O) What has been done: New lower control arms (Rough Country) New upper control arms (Custom) New track bar (Rough Country) Engine (fully painted, all new gaskets, new timing chain, new oil pump) New clutch, Pressure Plate, throughout Bearing Rebuilt front driveshaft New Floor Pans with POR-15 on top and bed liner underneath Wirewheeled and POR-15 the inside of the framerailes where I could Stainless steel brake lines Stainless steel evap line New radiator New AC lines New AC condenser New rear brake pads and drums painted with high temp paint New parking brake handle and cables New parking brake All new fluids Upgraded heavy duty steering Skyjacker 7000 steering stabilizer New steering box All new painted exhaust system with high temp paint (Except for CAT) No transfer case drop as Manual transmissions have a 2.5 inch longer driveshaft. https://cimg8.ibsrv.net/gimg/www.che...abf911e79d.jpg https://cimg5.ibsrv.net/gimg/www.che...2028c0654e.jpg https://cimg6.ibsrv.net/gimg/www.che...dcadab82c3.jpg https://cimg3.ibsrv.net/gimg/www.che...2acd3d1d86.jpg https://cimg4.ibsrv.net/gimg/www.che...26ab81ca9b.jpg https://cimg9.ibsrv.net/gimg/www.che...b8f86caff9.jpg https://cimg3.ibsrv.net/gimg/www.che...bb6ca26e87.jpg Has 3 inch BDS lift kit https://cimg2.ibsrv.net/gimg/www.che...17e8bd9ce7.jpg Engine bay is very clean https://cimg6.ibsrv.net/gimg/www.che...0d2a03fca8.jpg https://cimg7.ibsrv.net/gimg/www.che...48d0d3ba38.jpg https://cimg4.ibsrv.net/gimg/www.che...8840fab8c3.jpg https://cimg1.ibsrv.net/gimg/www.che...c93355ddff.jpg https://cimg2.ibsrv.net/gimg/www.che...5e641fe3ac.jpg https://cimg8.ibsrv.net/gimg/www.che...6358ef5d20.jpg Paint is all POR-15 https://cimg9.ibsrv.net/gimg/www.che...caf673bdf4.jpg The tunnel is not painted in this picture but I later painted it with POR-15 https://cimg0.ibsrv.net/gimg/www.che...31ec531f38.jpg The engine bay was painted with POR-15 then red over that so it is the factory colors in the engine bay. https://cimg1.ibsrv.net/gimg/www.che...c4be847bd3.jpg Engine is fully painted with all new gaskets, oil pump and timing chain. https://cimg2.ibsrv.net/gimg/www.che...fc5debf10b.jpg https://cimg7.ibsrv.net/gimg/www.che...58ade292f7.jpg https://cimg4.ibsrv.net/gimg/www.che...3c026a3e4c.jpg https://cimg0.ibsrv.net/gimg/www.che...206aa27c98.jpg https://cimg5.ibsrv.net/gimg/www.che...130b5ad34c.jpg https://cimg8.ibsrv.net/gimg/www.che...6729de909e.jpg Corrected pinion angle with fixed upper and lower control arms. https://cimg9.ibsrv.net/gimg/www.che...b2baf69945.jpg All Stainless steel brake lines with Rough Country Stainless steel brake line extenders. |
One of the few examples I've seen that deserves the price tag. Nice work. Might want to throw up the actual miles on the chassis. Good luck with the sale.
|
Thanks/Good Point!
Originally Posted by CR-Snow
(Post 3369233)
One of the few examples I've seen that deserves the price tag. Nice work. Might want to throw up the actual miles on the chassis. Good luck with the sale.
|
All times are GMT -5. The time now is 07:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands