Wiring for Lund Moonvisor
#1
Junior Member
Thread Starter
Join Date: Nov 2012
Location: MI
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
Wiring for Lund Moonvisor
Can someone tell me where the best place to run my wires for the Lund Moonvisor would be?
I ran them down to the kick panel on the drivers side, now where would be the best place to go from there?
I ran them down to the kick panel on the drivers side, now where would be the best place to go from there?
#3
Junior Member
If it were me I'd remove them from the Jeep and sell them on craigslist.
But, it's not me... so I'd run the ground wire to the closest convenient bolt with a ring terminal and run the positive wire to the park light circuit in the fuse box.
But, it's not me... so I'd run the ground wire to the closest convenient bolt with a ring terminal and run the positive wire to the park light circuit in the fuse box.
#4
Junior Member
#6
Junior Member
If there's any doubt you could run it to a relay then over to the park light circuit.
That's the only practical way I see doing it. I sure wouldn't want it on a separate switch.
#7
Seasoned Member
Join Date: Nov 2012
Location: Florida
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0L
Thread
Thread Starter
Forum
Replies
Last Post
moish
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-19-2015 11:55 AM
Fubar92627
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
09-16-2015 01:03 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)