xjr10

I bent my upper control arm mount on the axle side and was just looking for some help on getting a beefier replacement. Maybe add a truss to it? I'll be at 3" and 35s with short arms.

jrw7072009

I'm not a 100% sure what you are asking, but I like the Artec Industries XJ Truss. Its strong and worth the money. The TNT truss is junk IMO.

You can get the Artec on with Currie Joints.
http://www.artecindustries.com/Front...-XJ_p_335.html

Ianf406

I really like this one as it moves everything around a bit to fit better (no 1ton steering smacking the sway bar mount etc. http://ironrockoffroad.com/Merchant2...egory_Code=XDT
A bit pricey though- I was going to do this before I broke my 30.

xjmarc

I made some similar to these. http://www.rustysoffroad.com/rustys-...mount-kit.html

SeriousOffroad

http://www.seriousoffroadproducts.co...BRACKET-RE9986

xjr10

Will I have clearance issues on the truss with only 3" lift? How dufficult is it to make your own?

xjr10

Do you have any tabs for stock bushings?

SeriousOffroad

Huh?

Ya lost me.....

xjr10

I mean a short one that will mount on top of a truss with a large id to press in a stock bushing. I think IM just going to go with the one you suggested and build a truss around it.

SeriousOffroad

They do list one in the catalog, I'll get ya price.

xjr10

On welding the new mount on, do I just bolt it to the uca and weld it there the CA puts it at ride height or maybe droop my suspension a little since most of my travel is downtravel to keep there binding to a minimal?

SeriousOffroad

Put it in the same location as the stock bracket.

xjr10

I understand that I needs to go in the same location but how else would you get the angles perfect? With 3 arms connected bolting it to the 4th should put it exactly where it should be right?

xjr10

Bump

94XjSport94

Yes. Taking off that 1 arm shouldn't move it anything worth worrying over.