michael_lowexj

Have a 3" lift with blocks in the back and coils on the front. It has a lean to the front. What size coil spacers would reall level it out?

98XJ40K

Get rid of the blocks and get new leaf packs.
Measure from the axle tube to the frame rail, stock is something like 6" rear, front is around 6.75".
Once you have established how much lift you have, figure out how tall your spacer needs to be to get the same lift front and back.

michael_lowexj

Do they make a 3.5 inch add a leaf

jbsjunk

Usually those stop at 2" then fade.

michael_lowexj

I seen a 3". Get that a like a 1" shackle kit maybe?

98XJ40K

I'm pretty sure he means they settle at 2" after they are installed and slowly lose lift. This happens because your stock leaf pack has sagged quite a bit over the years and the single added leaf cannot hold all of the weight by itself. It will eventually give up and then you will just have an extra flat leaf in your pack.
If you can afford new leaf packs, go ahead and get them now. It will save you a lot of time and money in the long run.
Most new 3.5" packs will put you around 5" at first. They will settle and end up at the right height after they are broken in. So, don't try to match up the front until this happens, or you will have to adjust as the springs settle.