harken

Anyone know the linear distance (along shaft axis) between the rear face of the xfer case (231) and the center of the xfer case yoke on a AA sye mod. Would like the same info on the JB conversions 1031 sye. Thanks

gpXJ

MY JB conversions SYE should arrive on monday. I can get you a measurement then if no one else has posted prior to that.

charbur

are you talking about the blue distance below?



I just installed the AA SYE on my XJ a couple months ago I can measure it when I get home

harken

gpXJ and charbur,

Thanks. Charbur, yes, the dimension you have in blue is the one I want

charbur

Sorry thought I uploaded these last night. The distance I measured is 7 1/8" see picture below.





I am not sure what application you are using it on, but I also measured my rear driveshaft for reference. My application is a 1993 5 speed, 4.5" lift, 31" tires, NP231 with the AA SYE and a Chrysler 8.25" Rear End and my rear driveshaft is right at 35" at ride height. I am using a fron driveshaft out of a 1993-1995 Grand Cherokee 4x4 5.2L Automatic - Link below shows some stock front driveshaft lengths

http://www.myjeepxj.com/useful-infor...aft-infomation

harken

Thanks Charbur

RRXJeeper71

is anybody else running the AA SYE kit on their XJ?
I have an 2001 with AW4 auto transmission and NP 231/Dana 35 rear axle
I would like to know if anyone else has done this SYE kit and what length I need to lengthen my driveshaft/order new custom unit

RoyalXJ

It's best to install the sye first and take a correct measurement. If it's your daily driver, throw your from shaft in the rear until you custom comes in.