spray-in bedliner for the interior
#1
Newbie
Thread Starter
Join Date: Oct 2013
Location: n. al.
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
spray-in bedliner for the interior
I'm thinking of pulling out the carpet and having bedliner sprayed in its place. Looking for feedback from people that had this done. My jeep is a daily driver, so I'm concerned about heat & road noise.
#2
CF Veteran
Join Date: Jan 2015
Location: Minnesota
Posts: 2,152
Likes: 0
Received 7 Likes
on
7 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L
what I'm in the process of doing is bed lining, putting down a sound deadener and then putting just the carpet back without the pad. Only suggestion is give you is grind the floor to bare metal, use por 15 on it, then bed line it. Por 15 stops and prevents rust, as well as adds a good surface for the liner. I say do it! It won't be very loud if any louder.. It's a jeep anyway.. It's always loud!
#3
Newbie
Join Date: Jan 2011
Location: Kentucky
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
From my personal experience prepare to have holes in the floor board you never knew was there and rust but I fixed the wholes with sheet metal and rolled mine In I love it but make sure it's warm outside or it take a few days to dry
#4
Newbie
Thread Starter
Join Date: Oct 2013
Location: n. al.
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
well I hope I don't have holes & rust. what liner did you use?
#6
Seasoned Member
Join Date: Nov 2014
Location: Marysville, WA
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
Just Herculined my interior.
It was on average 38 degrees out and near 100% humidity when I did mine.
I took a wire wheel and ground down all my rust spots. Luckily all my rust holes were pinholes. I sealed them up with some epoxy and primered the floor.
I then Herculined it BUT it took 3-4 days to fully dry.
It wasn't even dry enough to start putting the interior back together until the 3rd day.
It's been just over a week now and I love it.
Can't comment much on heat because it's cold out but I can tell you that you will most definitely get more road noise.
It was on average 38 degrees out and near 100% humidity when I did mine.
I took a wire wheel and ground down all my rust spots. Luckily all my rust holes were pinholes. I sealed them up with some epoxy and primered the floor.
I then Herculined it BUT it took 3-4 days to fully dry.
It wasn't even dry enough to start putting the interior back together until the 3rd day.
It's been just over a week now and I love it.
Can't comment much on heat because it's cold out but I can tell you that you will most definitely get more road noise.
Trending Topics
#9
Member
Join Date: May 2014
Location: Albuquerque, NM
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1987
Model: Cherokee
Engine: 4.0L
Dont use Herculiner, it comes out super rough compared to other liners and is harder to clean. We did my friends bronco with it and it sucked. If you are going to cover it back up with carpet then it is fine to use.
I used Raptor liner in both the inside and outside of my XJ. It comes with a disposable spray gun and is crazy easy to spray on. If you decide to use Raptor liner and have any question PM me.
I didnt put back the carpet cause I like the rugged/basic look. I dont think that it is any louder but it will warm up a bit more over the tranny hump even with my aftermarket tranny cooler.
Here is a picture that kinda shows the floor but not very well. I can send you a better picture tomorrow if I remember if you want.
I used Raptor liner in both the inside and outside of my XJ. It comes with a disposable spray gun and is crazy easy to spray on. If you decide to use Raptor liner and have any question PM me.
I didnt put back the carpet cause I like the rugged/basic look. I dont think that it is any louder but it will warm up a bit more over the tranny hump even with my aftermarket tranny cooler.
Here is a picture that kinda shows the floor but not very well. I can send you a better picture tomorrow if I remember if you want.
#10
Seasoned Member
Join Date: Nov 2014
Location: Marysville, WA
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
I used 3/4 of a gallon. Rolled on. Very happy camper so far.
I wanted the rough / textured floor.
To clean it I figure I can just use a brush + water to hose it out.
Can just pop the floor plugs out of the pan to rinse the water / crud out.
I wanted the rough / textured floor.
To clean it I figure I can just use a brush + water to hose it out.
Can just pop the floor plugs out of the pan to rinse the water / crud out.
#11
Newbie
Thread Starter
Join Date: Oct 2013
Location: n. al.
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
thanks for the replies. I have several gallons of speedliner left over from some other trucks I've sprayed.
Did the rollers y'all used come with the liner you used?
Did the rollers y'all used come with the liner you used?
#12
Seasoned Member
Join Date: Oct 2013
Location: Idaho
Posts: 376
Likes: 0
Received 4 Likes
on
3 Posts
Year: 1991
Model: Cherokee
Engine: 4.0 Liter
Its a good idea to put a heat barrier over your muffler and cat if you aren't putting carpet back on. My floor actually got hot enough to melt part of a windbreaker while on a long trip, and even on short trips it'll cause any water on my floor to evaporate. I just used some Thermo-Tec adhesive backed heat barrier and it seems to have solved the problem.
#13
Member
Join Date: May 2014
Location: Albuquerque, NM
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1987
Model: Cherokee
Engine: 4.0L
Its a good idea to put a heat barrier over your muffler and cat if you aren't putting carpet back on. My floor actually got hot enough to melt part of a windbreaker while on a long trip, and even on short trips it'll cause any water on my floor to evaporate. I just used some Thermo-Tec adhesive backed heat barrier and it seems to have solved the problem.
Thread
Thread Starter
Forum
Replies
Last Post
SouthSeaPirate
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
32
04-17-2022 09:17 AM
Austindude2015
Cherokee Chat
17
12-28-2020 05:12 PM
Snajo
Other Vehicles. Other Jeep models & cars and trucks of other makes
0
09-26-2015 11:54 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)