spartan locker question
#1
Junior Member
Thread Starter
Join Date: Sep 2010
Location: Rapid City,SD
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Engine: 4.0
spartan locker question
ok so I have a dana 30 center line axle disconnect and i pulled the outer shafts and then the removed the c clip and slid the axle out. I then installed the locker and proceeded to reinstall the shafts, it was not possible to put in a c clip because of the locker.
so the question is do I need to put in a new one piece shaft or will it be fine the way it is with two piece and no c clip?
any help is appreciated...
so the question is do I need to put in a new one piece shaft or will it be fine the way it is with two piece and no c clip?
any help is appreciated...
#4
Senior Member
Join Date: Dec 2008
Location: Norco CA.
Posts: 510
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991 XJ SPORT 2 DR.
Model: Cherokee
Engine: 4.0 600 HP
no you can not use the locker with the c clip axle!
what you will have to do is get a one piece axle. remove the vac parts, axle and place a hub seal the same size as the new axle in side the vac area hole to keep the diff oil from running out.
what you will have to do is get a one piece axle. remove the vac parts, axle and place a hub seal the same size as the new axle in side the vac area hole to keep the diff oil from running out.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)