95xj10.5"

I have a 95 jeep cherokee that had bad timing, I pulled the timing cover and replaced the gears and chain, I even replaced the harmonic balancer to be on the safe side, I bolted everything up and I went to start it and it just turns over and doesn't get spark, so I changed the coil, dist cap, plugs and wires, all of which were old and I still cant get spark, any ideas please

LCFRJEEP

Only thing that comes to mind is to double check it is timed correctly. I see the list of parts you replaced, you dont mention the rotor button. I assume since you replaced the cap you also got a button too?? Check your negative battery cable and all of your connections. Are you certain you have no spark (arc it against the block)?? Good Luck!!

95xj10.5"

I did change the button, and I checked the position of the timing marks three times before I reassembled everything

95xj10.5"

Maybe I was informed wrong on where the timimg marks go on the gears, I beleive the larger one is the cam gear, where should it face, I have is set at 6 o'clock, and I beleive the the smaller one is the crank gear, where should it face, I have it set at 12 o' clock. Is this correct, or do they need to be set somewhere else, help please

freegdr

timing gears should be set like this on install

95xj10.5"

I googled that picture lol thank you in going to see if I have it right