sheet metal for floor board cancer
#1
Senior Member
Thread Starter
Join Date: Apr 2011
Location: Lima Ohio
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
sheet metal for floor board cancer
sheet metal for floor board cancer?
can i get replacements or do i need to get a parts jeep and a sheet metal bender
can i get replacements or do i need to get a parts jeep and a sheet metal bender
#2
Senior Member
Thread Starter
Join Date: Apr 2011
Location: Lima Ohio
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
never mind quadtratec has them but i need the piece that goes right under the rear bench seat i flipped them up today and i could see daylight
#3
Member
Join Date: Jan 2011
Location: Miamisburg Ohio
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
got my front driver floor pan from Raybucks... Cost less that Qtech ... i think Qtech wanted loke $90 plus shipping got mine shiped to door for that $90 ... goood luck
the website is raybuck.com
the website is raybuck.com
#4
Member
Join Date: Sep 2009
Location: Albany/Saratoga, NY
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999 Stone White
Model: Cherokee
Engine: 4.0
Raybuck's pans are a bit thicker/higher quality than others... Sherman auto parts is another source.
Discount jeep parts used sell the whole front/rear pans. If I had to do it over again (old 96) I would have gone this route. It was THAT bad.
Discount jeep parts used sell the whole front/rear pans. If I had to do it over again (old 96) I would have gone this route. It was THAT bad.
#5
CF Veteran
Join Date: Jan 2011
Location: Missouri
Posts: 2,251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0HO
if it is being covered by carpet just lay some sheet metal down and beat it till it fits, then weld it up, make sure you use paint on it afterwards
Thread
Thread Starter
Forum
Replies
Last Post
Snajo
Other Vehicles. Other Jeep models & cars and trucks of other makes
0
09-26-2015 11:54 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)