TheHollowNick

I've been searching everywhere, and turned up with nothing. I'm looking for the rugged ridge replacement tierod ends for there 1-ton set up. I just need the part numbers, so I can order them, or cross them over to moog... Much thanks.

TheHollowNick

bump

andrewmp6

Hit up http://www.seriousoffroadproducts.com/ he probably can help you.

xjmarc

Back when I ran it I contacted RR and they don't sell them seperately. And they use a weird metric thread that no one else seems to use. Mine is in my scrap pile now.

Ianf406

All I can find is they are M22x1.5- That is the same thread as the ZJ TREs so part number es3096l or equivalent SHOULD work. I recommend MOOG

Ianf406

I would probably call them up on Monday to verify the threading (pretty certain after locating it on a few sites). Pretty messed up if they can't help you/offer anything to replace them. It does not sound far fetched to me that they would use ZJ TRES at that price.

xjmarc

They aren't ZJ tie rod ends and the one on the tie rod where the drag link attaches is just like a chevy one ton BUT with different sized threads and smaller jeep sized bolt that attaches to the knuckle.

Ianf406

I have no idea as Ive never had it. All I could find was the threading. OP if you throw a pic up, maybe someone can Identify it. My old Rusty's 1ton used CJ TREs... Much shorter and thicker than XJs but still not enough to last very long on that setup.

Ianf406

Here ya go- from their parent company- pretty ridiculous

Right hand thread TRE- http://www.omix-ada.com/tie-rod-end-...inch-5210.html

Other side- http://www.omix-ada.com/tie-rod-end-...-7-8-inch.html

And middle- http://www.omix-ada.com/tie-rod-end-...inch-5211.html

In the install instructions via Omix-Ada it gives you part numbers:

18043.26 - 7/8” H/D Tie Rod End RH (2)
18043.10 - 7/8” H/D Tie Rod End LH (1)
18043.27 - 7/8” H/D Cross Over Tie Rod End LH

TheHollowNick

I only have on of the ones, with the hole in it, thats weird