plasma cut fenders?
#1
CF Veteran
Thread Starter
Join Date: Apr 2011
Location: central PA
Posts: 3,144
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
plasma cut fenders?
anybody ever use a plasma cutter to trim their fenders? i feel like it would work good on the front, since everyone says they cut like butter. but what about the rear fenders...should i stick with cut and fold, or does the plasma cutter just blow that out of the water? any info is appreciated!
#2
Seasoned Member
Join Date: Apr 2011
Location: muskogee ok
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
Model: Grand Cherokee
Engine: 5.2
It's hard to beat a cutoff wheel. With the plasma it will be hard to get a clean cut and the chances of a fire will be greater.
#3
I used an air hack saw.
Worked well with no sparks flying every where and easy to control and make curves.
This is the saw I used for the fender sheet metal also.
I also riveted past the spot welds then cut the fender above them.
i used long rivets as the inner fender and quarter panel start to separate above the spot welds.
Worked well with no sparks flying every where and easy to control and make curves.
This is the saw I used for the fender sheet metal also.
I also riveted past the spot welds then cut the fender above them.
i used long rivets as the inner fender and quarter panel start to separate above the spot welds.
#4
Junior Member
Join Date: Jun 2011
Location: Missouri
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Grand Cherokee
Engine: I6
I have worked with plasma cutters quite a bit, with out some type of guide to lean it next to and cut you would not get that strait of a cut. Also they cut so good and so fast there is no room for mess ups really. It might also mess up the pait around them i have never used one on painted metal before always raw metal..
Just me 2 cents! lol
Just me 2 cents! lol
#5
CF Veteran
Thread Starter
Join Date: Apr 2011
Location: central PA
Posts: 3,144
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
yeh paint was another concern...i think ill stick with a cut off saw of some sort...ive got enough layin around, just gotta find one that works lol
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)