Converted96

Ok, so I'm in the middle of my lift and I had to cut the trackbar bolt out of the axle side. It was a 15mm head and not sure of length. So I call up the dealer and tell them that I now need this bolt too. And verified it was the bolt that went into that special welded nut plate.

I got to pick it up today... at 9.82 for this stupid thing, and its a torx bolt and only about 3 inches long. I said that's not right. He looked it up again and said it was. I took it, will probably return it. I am not willingly putting a torx bit in. So does anyone have the bolt info or better yet a part number? Or should I just try to fit a ggrade 8 in there from the hardware store?

dogger15

just go the your local jy and pull one off another xj thats what i did when some how lost mine

lynskynbnd

I use a 10mm bolt, washers, and nut. Stripped out the OEM stuff years ago!

Converted96

I'm just wondering if the original bolt was a torx and the one I had in there might not have been original.

Xj88

Couldn't get by without removing the trac bar?

Converted96

Um I'm pretty sure your not insinuating running without the trackbar.. but no I have an adjustable one I am putting in.

Xj88

No hahahaha...I didn't realize you had an adj. One you were putting in

Hoooper

yeah im very certain the stock bolt isnt a torx bolt

Converted96

Lol, I don't think I woulda got to far.... yeah shoulda stated I had a new one going in.

Converted96

Yeah I was trying to tell them that it wasn't right

brian0128

For future reference,
Nut,hex, flange lock,m10x1.5 part#6506264AA
Bolt,track bar to axle part#6505549AA.

xjmarc

I broke mine long ago and run a 3/8" grade 8 bolt and nylon nut with some washers. And no it's not a torx head, that's for the sway bar and the rear track bar on a ZJ.