new rc 4.5 lift with a bad lean
#1
Newbie
Thread Starter
Join Date: Nov 2011
Location: Skook. Pa
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
new rc 4.5 lift with a bad lean
Hey guys this is about my 3rd xj,1st one I lifted myself. I have a brand new rc 4.5 lift kit with full leafs. I installed the rear set up and everything looks good. On the front I installed the lca's that came with the kit along with the new shocks and coils. I also bought new coil isolaters to replace the old ones. I got a new adj trac bar and did the rock n bounce to settle the axle in place like I read on here and it looks pretty well centered, but the front pass side is leaning a good amount. I measured the top of the stock tires that I still have on it to the bottom of the fenders without the flares and the pass is around 8 1/2 inch and the driver is around 12 so its like a 3 1/2 inch lean. Coils are seated in right and all that, even messed with the air in tires and still no change. Any ideas???
#3
CF Veteran
Join Date: Jun 2009
Location: Columbus, Ohio
Posts: 2,173
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0, comp cam, 99 intake, apn header, neon injectors, Thunderbolt 2.5" High Flow Cat
sounds like it's going to be a frozen shackle in the rear (yes, that would effect the oposite corner on the front), Or the track bar is not adjusted right? I could also be defective parts, I dunno, let's see pics.
#4
Newbie
Thread Starter
Join Date: Nov 2011
Location: Skook. Pa
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
Ill try to get some if I could today. Ill take a look at the shackles, the one was was really hard to move and I'm gunna unhook the tracbar and adjust it again and see if it sits normal. Im most positive it sat normal untill I drove it around the lot and over a lil dirt mound, so the shackle idea might be the cause. Ill mess around with it and report what happens. Thanks
#5
Newbie
Thread Starter
Join Date: Nov 2011
Location: Skook. Pa
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
Fixed!! The driver side shackle was forward to far, i loosened the bolt and drove it over some bumps and parked it on a flat surface and now it sits like a champ again! Thank You!!!
#6
CF Veteran
Join Date: Jun 2009
Location: Columbus, Ohio
Posts: 2,173
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0, comp cam, 99 intake, apn header, neon injectors, Thunderbolt 2.5" High Flow Cat
yeah, I had to replace both stock shackles on mine because they were rusting through, and also the bushing inside them was siezed around the bolts like that so they weren't getting the full range of motion. Glad ya got it figured out.
Thread
Thread Starter
Forum
Replies
Last Post
investinwaffles
Modified XJ Cherokee Tech
11
05-18-2021 12:02 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)