steelyglint

Hi Guys,

Well I'm fitting the first part of my lift tomorrow, RC Add a Leafs, the big ones, I bought new U bolts too, I've never tried anything like this before, the instructions supplied are pretty clear and I'm happy to go for it but before I do are there any "secrets" that I need to know?

Also when I reassemble the spring pack do I grease the leaves or assemble dry ?

Thanks guys

Martin

jeepboi

one thing i would recomend is puttin good jack stands under the frame and not usin the floor jack its easier in the long run and when since you bought new u bolt just chop the old ones off no need for them anymore

Xj88

Grease your center pins..leave the main leaf attached to the frame and shackle take the other leafs out insert your leaf into the packet in order of length...get some c clamps and tighten the pack down to the main leaf. The back was so easy for me...use a flat head and a hammer to get the pack clamps off..pb helps...only problem I had was recentering my axle to get the head of the center pin to fit in the plate hole.