Jeepfreak1020

Ok so I just finished my axle swap. Got everything all finished up e-break cable, but those wont be here till tomorrow. I wanted to back the jeep out of the garage to get it out. So I bleed all my breaks and everything. all set and ready, put it in reverse and the jeep wont move at all. It torks like its going to move but then dosent. Like all my breaks are locked up. If I stomp on it i can spin the tires a little but it wont move. So I jack the backend up and the tires unload. I keep it in the air and put it in reverse, tires spin backwards just fine. No problem at all. I pull the tires and adjust the breaks thinking that the drums are to tight. I loosen them up a little and try again. Nothing. Jeep torks but wont move. Well now the jeeps *** is out of the garage and I need to get it back in, I put it in N and wont move at all. I put it in 4 high and drive to try and drag it in, but it wont move, I hit the gas alittle more and all of a sudden I get it nasty ratch sound. Whats the problem? Im stumped and so are my brother and dad. Help me out out guys

freegdr

did you put the small bolt back in slide pin that holds the spiders in

Jeepfreak1020

Never touched anything in the diff. Picked them up from a guy who just had them in his jeep. and they went straight into mine.

44 rear, 30 front. ARB's front and rear, 4.56 gears

freegdr

you made sure the axle worked b4 you installed?

lolz_jeep

open up the diff your c clips in the rear may have fallen out and is causing it to bind

TheDale

If the rear axle will spin while on the jackstands, it sounds like your front axle is not spinning and is locked up.

TheDale

And you heard like a ratcheting type sound? Sounds like you just trashed your ring and pinion gears.

Jeepfreak1020

Just talked to the guy i bought them from. may of founf the problem. The axle came out of a 01 XJ. and I have a 98. The unit bearing is different from the 99's and up. So I would need calipers from a 01 to to make it work

Jeepfreak1020

How do I know if I trashed the ring and pinion??

freegdr

oops

freegdr

isnt the 01 low pinion and the 99 high pinion??????????

freegdr

different rotors maybe calipers same part numberhttp://www.jeep4x4center.com/product...number=5252985

posjeepxj

ive done the same thing. put 01 bearings on my 92 axle. got it all together and no go. took me a bit to figure out i had to put the 01 rotors on also

Jeepfreak1020

Yep that's it. I jacked up the front and the tires are locked up. But now I'm kinda worried about the R&P

freegdr

remove the brakes and see if it turns good by hand i think the noise was the brake prob