Iron Rock Offroad H&T
#1
Senior Member
Thread Starter
Join Date: Oct 2009
Location: Southern Utah
Posts: 532
Likes: 0
Received 1 Like
on
1 Post
Year: 1992
Model: Cherokee
Engine: 4.0 I6
Iron Rock Offroad H&T
Hey I just did my hack and tap Tuesday (1992 np242) and I measured per instructions for the drive shaft I got, and i cut off the excess spline. I only cut off 3/4 - 1 inch and hooked everything up. the length on the drive shaft is perfect, right in the middle, but my seal leaks It was put in right but i dont think my new yoke engages it well. Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
02-15-2024 08:09 AM
Austindude2015
Cherokee Chat
17
12-28-2020 05:12 PM
Freakn
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
52
10-04-2015 06:34 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)