Iro steering issue
#1
Senior Member
Thread Starter
Join Date: Mar 2011
Location: New Haven, IN
Posts: 956
Likes: 0
Received 1 Like
on
1 Post
Year: 1998
Model: Cherokee
Engine: 4.0L
Iro steering issue
I just got the iro steering installed on my xj. Just noticed today the joints are sitting all the way down and my drag link sits against my tie rod. Anyone else have this issue?
#2
Former Sponsor
Join Date: May 2010
Location: meriden Ct
Posts: 2,181
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
Make sure the joints are loaded against each other. can you rotate the drag link? they are very close, and the heims will rotate and they may rub, its normal for waht I have seen with those. but if one heim is up and one down and the drag link cant rotate, then it will cause a problem
#3
Senior Member
Thread Starter
Join Date: Mar 2011
Location: New Haven, IN
Posts: 956
Likes: 0
Received 1 Like
on
1 Post
Year: 1998
Model: Cherokee
Engine: 4.0L
Yeah I can rotate it up and down but it touches the tie rod. I haven't noticed it driving just seems the heims may have loosened up our something
#4
CF Veteran
Join Date: Jun 2009
Location: Columbus, Ohio
Posts: 2,173
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0, comp cam, 99 intake, apn header, neon injectors, Thunderbolt 2.5" High Flow Cat
I have the same setup on mine. You have to hold the drag link up, rotate the heims all the way down on both ends, and tighten the hell out of that sucker. You don't want the bend any lower than the heim joint. Watch the clamp on the axle end, I had it turn around the wrong way and the bolt rubbed the inside of my tire when I turned left. Cut down a kl71, and that mistake cost me about 200 bucks to replace the tire. Once you have it in right though, it's an excellent setup.
#6
CF Veteran
Join Date: Jun 2009
Location: Columbus, Ohio
Posts: 2,173
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0, comp cam, 99 intake, apn header, neon injectors, Thunderbolt 2.5" High Flow Cat
np, I'll get some pics of mine tommarow. Just make sure that bend is at least level with the end of the bar, if not a little higher when you tighten that down. it'd help to have a good strong helper to hold it in place while you crank on that nut with a cheater.
Thread
Thread Starter
Forum
Replies
Last Post
southfloridajeeps
Modified XJ Cherokee Tech
32
03-04-2023 01:10 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)