trailcreepers

Here's a link for the steel 7 switch plate. 1/2 the price of the 3d printed plastic. https://www.ebay.com/itm/1997-2001-J...g/192387675681

wizardpc

That is a much better option for people who want to go with the contura/carling style switches and lose the OEM switches

cgeiss97

just now starting to put lights and a winch on my jeep. how did y'all run your switch wires through to your consoles. ive got one running through the a-pillar right now and don't like it

trailcreepers

I just drilled through the fire wall. Since I am using relays to activate the lights, I just ran a thermostat wire from the switches to the relays. That gave me 5 wires in a narrow sleeve.

SteveMongr

There is a rubber grommet on driver side firewall that enters cab near brake pedal. Has room for additional signal wires. I understand there is also a grommet on passenger side firewall on 1997+.

MoparNJeep

Not mine but this guys XJ has a switch about everywhere you can imagine. So many in fact there is no room for the factory dash. Haha

wizardpc

That's the Tiger XJ

trailcreepers

That looks like a lot of trimming...how about this one?

4.3L XJ

Here is my switch panels for my fans and on board air. I just cut holes in the factory plastic switch panels

4.3L XJ

My most recent project was to make new panels to go in place of the idiot light panel above the headlight switch and a new panel to replace the clock and cig lighter panel. Added a new cig lighter power source as well as two USB sources

Greenz

Made this one. Requires lots of trimming and fitting but it was an inexpensive project while I was gimped up.

Kaskin

Just bought this 01 XJ. Stoked... Any whoo, this is where I'm putting the switches. Above indicator lights will be wired to radio illumination wire. They will light up when lights are on. The holes below them, now house LED's. They will will light up when switch is on...

JK253

Thanks for this one, just ordered. One complaint about the newer style XJ is that there's absolutely no dash area to put any switches, and I'm wary of putting my locker switches anywhere on the center console where something can be dropped on them and activating.

Ralph77

Also here if you need more room. But you do have to drill. No problem drilling from the engine compartment. Plenty of room.