My 01 cherokee has a D35 but im upgrading to the C8.25. So my question is will my D35 driveshaft work with the C8.25? My jeep has stock suspension.

 

The D35 has a shorter pinion than the C8.25 and D44, and has a 1" longer driveshaft to accomodate. If you are lifted then you might be alright, otherwise you will need a shorter driveshaft.

 

Get the correct shaft.

 

Ok will do. Thanks

 

Damn wish I knew this before I snagged my D44. At least I haven't put it in yet.

 

wouldn't an SYE help out here? IIRC, had to lengthen my stock shaft

 

Lift height was not stated so it's unknown if an SYE is needed or already installed.

 

Yes it was:

My 01 cherokee has a D35 but im upgrading to the C8.25. So my question is will my D35 driveshaft work with the C8.25? My jeep has stock suspension.

Have another cup of coffee Frank.

 

Beer...better make that a beer.

 

or six.

 

Breakfast of champions..........

 

Will a drive shaft out of a 94 or 91 checkee with a c8.25 fit my 01 cherokee with a 2000 c8.25 in it?

 

Yes.

 

Great thanks

 

95- and 96+ had different main shaft on the rear of the transfer case. The later models are about 1.25" shorter than earlier models (if all other factors are the same). The earlier will install but might be too long and bottom out if the jeep isn't lifted over stock.