Post one like this......

 

Were it comes into rear end

 

Yes that's the angle were concerned with

 

Here's the pictures of that

 

That's pretty good actually don't think I don't think id shim any.

 

What size tc drop you got ? I ran 6.5 lift on stock shaft but 4 .5 spring drp shackles and tc drop. No vibes.....

 

1" tcase drop then I don't know how to get the angle were it won't bind up next to the tcase

 

Is yoke hitting itself up front or loose on tranny?

 

Your axle does this driving so don't think highers the cure might wanna install longer yoke and try. Orr smaller blocks and shackles which will attack a different direction.

 

I think the yoke is hitting there

 

I thought bout doing away with blocks completely and using iron man fab adjustable rear shackles but gotta wait till next payday

 

How's your trans mount doing? Read that sometimes that causes vibes just because of the change in angle after so much time.

If I can hijack quickly, how does this look for a pinion angle?

 

I'll look at trans mount tomorrow

 

How do you check trans mount

 

http://www.jeepforum.com/forum/f11/b...ement-1046436/

There's some way to check for clearance. If you can look up there and see it deteriorated that would be a good sign, ha. Otherwise they're 30-40 bucks and usually bad if the jeep is old and its never been replaced before. Wise to do the motor mounts at the same time, if you can.