aj6

is there a way to get GC CV joints in to a cherokee?

they share both the same d30 so i dont see why it wont work but as anyone tryed it?

ct67_72

Why would you want to put in a weaker joint?
But to answer your question. Yes the GC vb axles for just the same.

Lowrange2

How about install a set of RCVs? They look similar.

aj6

more points of contact and sealed from water and dirt, yeah i wanta put weaker joints in..

ive tryed GC ones but they didnt fit. did i get the worng ones?




rcv are way over kill for my stock jeep....

nickxj94

i would love to but there worth more than my xj lol!!

Bustedback

More points of contact? Yes. But the contact surface area is a lot smaller than in a regular Ujoint. The only real advantage a CV joint has over a Ujoint is smoother operation at extreme angles.

rideordie66

Your STOCK jeep has no need to have anything other than the STOCK parts that came with it. You can twist your driveshaft with those week u joints that Jeep put in it from the factory.

ct67_72

lol more points of contact? how much area is there compared to 4 ujoint caps?
u-joints arent sealed from water and dirt?
What did not fit? I have used them for spares many times. I have on in the back right now as a matter of fact

Jmb94

A design as simple as the freaking U-Joint probably doesn't need much extra protection than a little grease... Better put Rustoleum on your hubcaps too...

aj6

do you have abs on yours?


its a stock jeep yes it is. d30 came with cv's in them in the GC i thought it would work. i had to do an emergency repair with little time. i just wanted to put two cv's in at $79 each and fix my u joints later.

the ones i got where to long on both side's by 6 in i though i maybe i got the worng ones.

ct67_72

no I dont have abs. If the shafts were 6" too long they gave you the wrong ones some how. There are no different width dana 30's that came in cherokees/grand cherokees. We have had to run to the parts store to get them before to get a jeep off the trail