can this work
09-23-2011, 07:51 PM
#1
CF Veteran
Thread Starter
Join Date: Oct 2010
Location: Long Island N.Y.
Posts: 1,889
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1999
Model: Cherokee
Engine: I6 4.0
can this work
Is it ok if i put the rough country long arm cross member on i drilled the side of the frame all bolts are tight but on the passenger side the factory stud snapped and i cant get it out will it be alrite to have the 2 lower and 2 upper instead of the 3 lower?
09-23-2011, 08:55 PM
#3
Newbie
Join Date: Oct 2010
Location: long island ny
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 high output
Its not as strong simple as that. on the other hand mine brok about a year ago when i installed it and didnt fix it untill about a month ago and nothing too serious happend but in the long run think about replacing it
09-23-2011, 09:46 PM
#5
CF Veteran
Join Date: May 2011
Location: EAFB, SD
Posts: 1,381
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Cherokee
Engine: 4.0 HO
I wouldn't really weld it in...you could do it the right way drill the old bolt cut into the unibody weld in a new nutplate and install the bolt.
09-23-2011, 10:36 PM
#6
CF Veteran
Thread Starter
Join Date: Oct 2010
Location: Long Island N.Y.
Posts: 1,889
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1999
Model: Cherokee
Engine: I6 4.0
Tonite i cut open the floor and i see where the bolt is stuck tomorrow im going to weld a nut to it and try to break it out
Thread
Thread Starter
Forum
Replies
Last Post
Rotorhead
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
20
09-23-2023 04:17 PM
Aryl
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
04-10-2019 09:07 AM
ammonllewis1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
08-31-2015 11:27 AM
Chick-N-Picker
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
21
08-27-2015 12:27 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)