Advise on finish work for body welds
#1
Senior Member
Thread Starter
Join Date: Jun 2011
Location: New Mexico
Posts: 764
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0
Advise on finish work for body welds
Ok so like the title states, I have done what I refer to as a mini tub on the rear wheel wells, cut in some hood vents, choped my fenders of course etc etc... the question is I have gotten to the point where my sheet metal welding skills are quickly becoming sharper but my question is how should I go about finishing the areas? The welds are smooth and solid and I used a blending disk to smooth everything out but this is my first run at body modification on a vehicle so I have primer over the areas now but do I use a VERY thin layer of filler like bondo or the likes to ensure a professional looking job or would it be fine just priming it like I have and move on with my other plans. I have everything in the garage for Monsta lining her eventaully but the exo and other armor pieces have to be finished and or burnt in before I move to that level.
Thread
Thread Starter
Forum
Replies
Last Post
Aryl
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
04-10-2019 09:07 AM
xjmachine
Fabrication & builders section.
25
09-27-2015 08:22 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)