Thoughts on a tire carrier.
Ok so my thought is for a pivot point for a rear swing tire carrier build is to use 2 hiems in a single plane vertical shear. With about a 4-5" separation. 2 separate bolts.
The tire is a 35 with a steel rim. The tubing that would be use for the carrier would be .120 wall. Do you guys think this would hold up? |
So no one has any thoughts one this at all?
No one? |
Got a sketch? Sounds good to me.
|
You talking drop down or swing out?
|
should work out fine. would put just as much stress on the bumper mounts as a traditional spindle though.
I did something similar except tied it into the body. It was super solid and held a 35" tire on a steel rim and a full can of gas through jumping and hard wheeling without issue. even held a 37 later in its life. http://sphotos-a.xx.fbcdn.net/hphoto..._5254550_n.jpg |
Originally Posted by ktmracer419
should work out fine. would put just as much stress on the bumper mounts as a traditional spindle though.
I did something similar except tied it into the body. It was super solid and held a 35" tire on a steel rim and a full can of gas through jumping and hard wheeling without issue. even held a 37 later in its life. |
Originally Posted by busted-knuckles
(Post 2095615)
Ya this is exactly what I was thinking of doing but both mounts on the bumper.
|
Ya my plan was to have it swing out horizontal, and flat. So the plan was to mount them on the bumper.
|
All times are GMT -5. The time now is 04:01 AM. |
© 2024 MH Sub I, LLC dba Internet Brands