Modifying my bumper today...needs some opinions before i break out the plasma......
#1
Senior Member
Thread Starter
Join Date: May 2011
Location: Metro Detroit
Posts: 590
Likes: 0
Received 1 Like
on
1 Post
Year: 1993
Model: Cherokee
Engine: 4.7 Hesco stroker
Modifying my bumper today...needs some opinions before i break out the plasma......
I'm about to chop up my Rusty's tube bumper....what do you guys think? I'm chopping it at the green tape lines....basically just removing the ends of the lower tube. I think it will look much better. I was never really a fan of this bumper but it came with it. I think I may plate in the center section too.....
#3
CF Veteran
Join Date: Jan 2010
Location: Virginia Beach by way of Michigan
Posts: 5,482
Likes: 0
Received 24 Likes
on
24 Posts
That chop will look good. You could take the ends you cut off, weld them to the top tube of the bumper and then weld a piece of plate on top of those, run a small gusset on each side, and end up with a winch plate You'd need to move your lights a little further to the sides but that's not hard.
Trending Topics
#11
Senior Member
Thread Starter
Join Date: May 2011
Location: Metro Detroit
Posts: 590
Likes: 0
Received 1 Like
on
1 Post
Year: 1993
Model: Cherokee
Engine: 4.7 Hesco stroker
They are 31x14x15.....Yeah, they are stupid wide. I got them dirt cheap off of Craigslist. They are just temporary until I decide which size/brand of tires to go with. I'll probably do some 31x10.5 Federals here soon.
Thread
Thread Starter
Forum
Replies
Last Post
lpresnell
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
5
09-08-2015 10:59 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)