help decleration vibrations with 3.5 lift
#1
Newbie
Thread Starter
Join Date: Jan 2011
Location: maryland
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Year: 98
Model: Cherokee
Engine: 4.0
help decleration vibrations with 3.5 lift
I currently installed a rubicon 3.5 super ride lift ended up getting 4 1/2 inch lift in the front 5 inch lift in the rear put new leafs control arms everything .
now when I let off the gas I have a slight vibration going down hills etc>...... was wondering if this could be fixed by a axle shim if so what size for a quick fix until i can get the sye and drive shaft .
We already dropped the transfer case about a inch and that help the problem greatly . It is more annoying than anything else.
please give me any scenario you think might work or places to get the sye and shaft where you were happy with the service
now when I let off the gas I have a slight vibration going down hills etc>...... was wondering if this could be fixed by a axle shim if so what size for a quick fix until i can get the sye and drive shaft .
We already dropped the transfer case about a inch and that help the problem greatly . It is more annoying than anything else.
please give me any scenario you think might work or places to get the sye and shaft where you were happy with the service
#2
I'm having the same problem except it happens if I accelerate real hard too. I ordered a hack n tap from Irion Rock offroad. Didnt get home yet to put it in yet. I will let everyone know how it went and the results though.
#3
Junior Member
Join Date: Oct 2010
Location: Washington
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
I get the same vibes between 35 and 45 mph during decel. You'll have to figure out your own shim with an angle finder. Go to Tom Woods website and read the tech info on driveshaft angles.
#4
Newbie
Thread Starter
Join Date: Jan 2011
Location: maryland
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Year: 98
Model: Cherokee
Engine: 4.0
thanks for the info
thanks for all the info sounds like a common problem calling rubicon tmrw sounds like a 6 * shim will do the trick
Thread
Thread Starter
Forum
Replies
Last Post
lgrant
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
07-05-2022 12:19 AM
rdr8887
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
11
01-27-2020 09:24 AM
SouthSeaPirate
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
09-07-2015 06:47 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)