Mounting Lights to Stock Roof Rack
#1
Member
Thread Starter
Join Date: Mar 2009
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: Inline 6
Mounting Lights to Stock Roof Rack
Is it possible to mount lights on the stock rack? I know it has somewhat of a curve to it, but what i'm more concerned about is if i drilled through for mounting, would the roof rack crossbar be too thick for the lights to mount through a hole drilled in them?
#2
Registered Users
Join Date: Mar 2009
Location: Pa
Posts: 1,401
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
it works good
#5
Registered Users
Join Date: Mar 2009
Location: Pa
Posts: 1,401
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
Trending Topics
#8
I put 4 BAJA lights I got from Walmart on mine and they look and work great. Take a torx bit and loosen the driverside rail that runs from the front to back. Then drill a hole through the roof where the rail goes to run the power wire.Use the existing screw for the rail mount for your ground.Put a bead of silicone in the hole you drilled after you run the wire. Remount the rail ,drill your holes for the lights, mount your lights . Hook it all up and run your wires in the cab bahind the trim coming down the windsheild . And your good to go. It took me about 2.5 hours and well worth it . They work great and their only $20 per pair at Walmart. I think they are 4x7 inch or 5x8 . Use wire loom on the roof wires and your done. Good luck. Put a 2x4 under the rack so you dont over drill and go into your roof.
#9
#10
Seasoned Member
Join Date: Aug 2009
Location: Roanoke, Va
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
#11
CF Veteran
Join Date: Jun 2009
Posts: 5,383
Likes: 0
Received 4 Likes
on
1 Post
Year: 1988 limited
Model: Cherokee
Engine: 4.0 litre
Ok i have five, two with yellow glass and three with white that run on different switches. All the wires pass inside the roof rack bar and the ground is bolted on the roof.
The two positives go around the rail, enter the weather seal, and go in where the rubber of the door harness is.
The two positives go around the rail, enter the weather seal, and go in where the rubber of the door harness is.
#12
#13
CF Veteran
Join Date: Jul 2009
Location: New Jersey
Posts: 2,522
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: l6 HO
i am definetly going to do this.. tomorrow.. lol.. can you run all 4 bajas ( they sell them near me too.. 20 bucks a pair) into each other so they all work off the same switch?
Thread
Thread Starter
Forum
Replies
Last Post
RunnerInPink
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
25
10-10-2017 10:34 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)