warthog

Awesome thanks

krkx93

not a problem

gobbs_stopper

My CB Radio and antenna mount



On my spare tire mount



The wires clears the slip pin

iwheeljeepxj

i've never seen the antenna mounted on the front bumper so thats were i put mine. i like how it looks. and this way i know were my front bumper is at, at all times.

gobbs_stopper

its ok but i think it would get caught on a tree limb or something. how do you have it grounded.

iwheeljeepxj

the mount goes threw the front bumper witch would be the ground. and if my antenna hits a tree branch well i might as well back up and try again because my windshield isn't as flexible.

REWSTER

here is mine, i used some scrap i had laying around







just get some cardboard and make a template

96_xj

if you have a roof rack you mount it that way as well. my whole rack is grounded and i run a 103" stainless steel whip with no problems, you hear it when it hits trees and stuff and makes an RC car look bahahaha

Camo Cowboy

I have tried everthing and have run into a problem of some sort with all mounts until I found lil wil. I use to run a 4' fire stick and got good reception but my lil will had noticably better reception and now i dont worry about hitting it on anything. look into it http://www.bellscb.com/products/ante...Little_Wil.htm

you can find them on ebay for 25-30 bucks plus shipping

Magnetic base took the guess work out of all of it. Best money I have spent on my jeep mods.

mrmikey32

i have the k30 series of the little wil.

magnetic are so much nicer

AWOL

here's my setup.

the headliner will tuck back over it.

SloPok

I did something like this, only i used the 3 bolts holding in the tail light and added strenth across the top.

Richliveshots

Here is what I went with. The stainless steel fender mount with a 102" stainless steel whip. Very important to run a good quality stiff spring. Especially if you run a whip or a fire stick because it will rip the screws right out of the fender. I’ve been running this setup for about 6ix years other than an occasional tightening of the screws, have had no problems. However, the best location for a ground plane antenna is dead center of the vehicle (for best all around reception).

rockhound23

interior mount..passenger side under glove box and doesn't interfere with glove box opening

rear mount is just drilled into the body panel backed by a small piece of sheet metal for sturdiness. Wire comes thru small hole cut in the rubberstopper/grommet under the tailight housing

rockhound23

like those diamond plate rockers, make 'em yourself?