Ok my question is can i have these cut down to fit under my 84 wagoner if so were would i get the axel's

 

run them full width also im guessing it a 10 bolt and 14 bolt sf the 10 bolt is junk i wouldnt use it get a d44 thay came in some chevys i think they were closed knuckle

 

Plan on a t-case swap since Chevys are passenger side drop. X2 on the 10 bolt but you can find open knuckle 44s.

 

Running full-width would be preferable, but if that’s not in-line with your build goal you can have the existing shafts cut and resplined. It is not a difficult operation and should not be expensive.

Also, since the housings will be shortened a somewhat arbitrary length, finding a drop-in shaft may not be feasible.

 

thats what i will do cause i really dont want to cut them and i am getting the whole truck