xj man workin on a zj.
#1
Seasoned Member
Thread Starter
Join Date: Nov 2008
Location: belleville il
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
xj man workin on a zj.
my parents ahve a 2004 grand cherokee wit a 4.0. and when u start it sometimes it reves up to about 3000 rpm and stays there for a few min and then finally settles back down. what can make it do this?
#2
Senior Member
Join Date: Dec 2008
Location: Punxsutawney Pennsylvania
Posts: 831
Likes: 0
Received 1 Like
on
1 Post
Year: 1988
Model: Cherokee
Engine: Renix 4.0 I6
stays there for litterally a few minutes?? what if you start driving it around right when you turn it on does it stay at 3 grand when you put it in drive??
#3
Seasoned Member
Thread Starter
Join Date: Nov 2008
Location: belleville il
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
it stays there for 2 or 3 min. and when i put it in drive and keep my foot on the brake it runs about 1800
#6
Seasoned Member
Join Date: Sep 2008
Location: Medicine Hat Alberta
Posts: 318
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Grand Cherokee
Engine: 5.2
Yep go to chrysler and pay them 100bucks for the sensor and change it. if it works your good to go.
But to encourage you I would say that will fix it. I had the same issue with mine. I used to try to take off while sitting at a red light. That was kinda the last straw for me so I swapped it out. takes about 10 to change. No issues since.
they would probably charge you as much to test it.
But to encourage you I would say that will fix it. I had the same issue with mine. I used to try to take off while sitting at a red light. That was kinda the last straw for me so I swapped it out. takes about 10 to change. No issues since.
they would probably charge you as much to test it.
Trending Topics
#8
Seasoned Member
Thread Starter
Join Date: Nov 2008
Location: belleville il
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
yea thats what one of the guys i worked with said. is there a way to kno if thats bad i dont really kno much bout it.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)